Glacier Heat TENS Quick Start Manual

GLOVE, SOCK AND SLEEVE/WIRELESS TENS MACHINE
Quick Start Guide
Plug the square unit in and charge to a full charge. While the battery is still charging, the light (next to the plug) will be red. Once it is fully charged, the light will change to Blue.
remove all metal jewelry from the area being treated.
Connect the wireless device to the garment that has been placed on the body. Make sure the garment has close contact with the skin.
Hold the Power Button for two seconds, the light will begin flashing blue. Press the ON/OFF Button on the remote control and the left red light will illuminate which shows MODE 1. The mode is the manner that the tens is pulsating. The intensity is the strength of the pulses. Once a new mode is set, the intensity is reset to level 1. There are 6 modes on the device. Press M to change the mode.
Simply press the to INCREASE INTENSITY or to DECREASE INTENSITY. If you need to stop the
device immediately press the Play/Pause Button to restart press the Play/Pause Button again.
Treatment will automatically stop after 20 minutes. Treatment can be stopped at any time by pressing the ON/OFF button on the remote control. DO NOT remove the device until the treatment has stopped.
Mode 1 - Left Red Light Mode 2 - Right Red Light
Mode 3 - Both Red Lights Mode 4 - Left Green Light
Mode 5 - Right Green Light Mode 6 - Both Green Lights
Intensity Levels 10
Cautions & Warnings: Do not use on head. Do not use if you have a pacemaker or suspected or diagnosed
epilepsy or heart disease If you are pregnant, please check with your health care provider before using. If device becomes uncomfortable or causes pain, discontinue use immediately. Do not use over open or damaged skin. Remove all Jewelry in the treatment area.
Questions? sales@glacierheat.net
Loading...