Glacial 8LDIECH-SC-WFC-SSF, 8LIECH-SC-SSF-SSS-NP User Manual
IMPORTANT: If you have a question or problem, please contact
info@eastwestintl.com for assistance.
Self cleaning
Hot & Cold Hidden
Bottle Water Cooler
with Display
Model # 8LDIECH-SC-WFC-SSF
TO REDUCE THE RISK OF INJURY AND
PROPERTY DAMAGE, USER MUST READ
THIS MANUAL BEFORE ASSEMBLING,
INSTALLING & OPERATING DISPENSER.
SAVE THIS MANUAL FOR
FUTURE USE
USER MANUAL
8LDIECH-SC-WFC-SSF © 2012 Electrotemp Technologies Inc. PN:5M009433X1
SAFETY PRECAUTIONS
To reduce risk of injury and property damage, user must read this entire manual before
assembling, installing & operating dispenser.
Failure to execute the instructions in this manual can cause personal injury or property
damage.
This product dispenses water at very high temperatures. Failure to use properly can
cause personal injury.
When operating this dispenser, always exercise basic safety precautions, including the
following:
•
Prior to use, this dispenser must be properly assembled and installed in accordance with this
manual.
• This dispenser is intended for water dispensing only. Do NOT use other liquids. Do NOT use
for other purposes. Never use any other liquid in the dispenser other than known and
microbiologically safe bottled water. Warranty is void if used for any other liquids including
coffee, tea, juices, beer or wine.
• For indoor use only. Keep water dispenser in a dry place away from direct sunlight. Do NOT
use outdoors.
• Install and use only on a hard, flat and level surface.
• Do NOT place dispenser into an enclosed space or cabinet.
• Do NOT operate dispenser in the presence of explosive fumes.
• Position back of dispenser no closer than 4 inches from wall and permit free airflow between
wall and dispenser. There must be at least 4 inches clearance on the sides of the dispenser to
permit airflow.
• Use only properly grounded outlets.
• Do not use an extension cord with your water dispenser.
• Always grasp plug and pull straight out from outlet. Never unplug by pulling on power cord.
• Do NOT use dispenser if cord becomes frayed or otherwise damaged.
• To protect against electric shock, do NOT immerse cord, plug, or any other part of cooler in
water or other liquids.
• Ensure dispenser is unplugged prior to cleaning.
• Never allow children to dispense hot water without proper and direct supervision. Unplug unit
to prevent unsupervised use by children.
• Service should be performed only by a certified technician. Please contact us at 888-828-1426
for assistance.
WARNING
!
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 888-828-1426 for assistance.
2
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
GROUNDING INSTRUCTIONS
For a grounded, cord-connected water cooler:
This water cooler must be grounded. In the event of a malfunction or breakdown, grounding will reduce the risk of
electrical shock by providing a path of least resistance for electric current. This water cooler is equipped with a cord having
an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is
properly installed and grounded in accordance with all local codes and ordinances.
Improper connection of the equipment-grounding conductor can result in a risk of electric
shock. Check with a qualified electrician or serviceman if you are in doubt as to whether the
appliance is properly grounded.
Do not modify the plug provided with the appliance-if it will not fit the outlet, have a proper outlet installed by a
qualified electrician.
A 120 volt, 60 Hz., AC only, 15 amp, fused electrical supply is required. A time-delay
fuse or circuit breaker is recommended. Do not overload the ciruit, provide separate circuit,
if required, to serve only this appliance.
This water cooler is equipped with a power supply cord having a 3 prong grounding plug.
To minimize possible shock hazard, the cord must be plugged into a mating, 3 prong,
grounding-type outlet, grounded in accordance with local codes and ordinances,a mating
outlet is not available, it is the personal responsibility and obligation of the customer to have
the properly grounded outlet installed by a qualified electrician.
If codes permit and a separate ground wire is used, it is recommended that a qualified
electrician determine that the ground path is adequate.
Do not ground to a gas pipe.
Check with a qualified electrician if you are not sure the water cooler is properly grounded.
Do not have a fuse in the neutral or ground circuit.
“Please make sure that ELECTRICAL OUTLET IS PROPERLY WIRED
TO CORRECT SIZED CIRCUIT BREAKER OR FUSE AND PROPERLY
GROUNDED. MUST BE WIRED TO HAVE CORRECT POLARITY.
WARNING
!
WARNING
!
SAFETY PRECAUTIONS --Electrical Requirements
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 888-828-1426 for assistance.
3
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 888-828-1426 for assistance.
TABLE OF CONTENTS
KEY INFORMATION FOR FUTURE USE
Please register your dispenser immediately at
www.electrotemp.com
For future support please record your serial number (located on
label on back of dispenser) and date purchased. Staple your
receipt to manual.
You will need this information to obtain warranty service.
Product Self Cleaning Hot & Cold Hidden
Bottle Water Cooler With Display
Model Number 8LDIECH-SC-WFC-SSF
Serial ID Number
Date of Purchase
Safety Precautions 2
Safety Precautions-Electrical Requirements
3
Key Information for Future Use
. 4
Specifications
5
Parts & Features
.. 5
Assembly
6
Cleaning Prior to Initial Use ..
.. 6
Installation
. 7
Operation
.. 8
Proper Care & Cleaning
. 12
Display’s Operation explanation
. 14
Troubleshooting
16
Limited Warranty
17
4
SPECIFICATIONS
Power Supply 5 AMPs
Refrigerant Type R-134A
Cold Water Power
＜100Watts
Cold Capacity / Peak Hour 1 Gallon / 3.79 L
Cold Temp Range 3°C – 10°C / 37.4°F - 50°F
Hot Water Power 425 Watts
Hot Capacity / Peak Hour 1 Gallon / 3.79 L
Hot Temp Range 80°C – 92°C / 176°F - 197.6°F
Dimensions 102.8 cm H x 32 cm W x 38.2 cm D
40.8 inch H × 12.6 inch W × 15 inch D
Net Weight
PARTS & FEATURES
37.5 Ibs / 17Kg
1
2
1
2
3
3 4 5
4
5
6
6
7
7
8
8
9
9
10
11
10
11
12
12
13
13
14
14
21
15
15
16
17
16
17
18
18
19
19
21
20
20
Control: Hot Water
Hot Water Release
Control: Cold Water
Tap: Hot Water
Tap: Cold Water
LED Night light
Drip Tray
Door
Bottle Tray
Cold Power Switch(Energy Saving)
Hot Power Switch(Energy Saving)
Carry Handle
Cooling Thermostat
Drain Plug
Bottle Probe
Door Switch
Water Pump
Power Cord
Filter
LCD Display
Condenser
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 888-828-1426 for assistance.
5
ASSEMBLY
Keep plastic bags away from children.
1. Remove dispenser from packaging.
2. Unpack drip tray and insert into dispenser.
3. Remove protective packaging from around probe.
4. Properly dispose all of packaging.
CLEANING PRIOR TO INITIAL USE
To remove any odors or dust that may collect during shipment, you must clean
dispenser prior to first use.
Time Required: 45 minutes.
1. Move dispenser away from wall and turn it 90° in either direction.
2. Turn power switches to OFF.
3. Unplug power cord from wall outlet.
4. Remove water bottle and probe from water bottle.
5.
Place a 2 gallon or larger bucket under the probe
assembly.
Dis-assembly probe assembly wash probe parts
by hand in soapy water or in the dishwater.
6.
Romove air filter and wash in soapy water.
7.
8.
Submerge probe hand in the soapy water and rinse properly.
9.
Assemble back all parts of probe assembly.
10. spay dispensing nozzles of water faucets with chlorine solution (1 teaspoon of
unscented bleach in one glass of water ).
A
B
maximum extension 1.5-2 inches
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 888-828-1426 for assistance.
6
Loading...