G KINDLY ELECTRONIC KDL C26 User Manual

KDL-C26

2-3

2-3

Micro USB charging cable included

FCC ID:2ALR9-KDL-C26

voice prompt

Connect the micro USB plug of the included Micro USB charging cable to the
Micro USB charging port on the back of the speaker.
Connect the other end of USB plug to a USB power source. The red indicator light will
be on during charging. If charging does not start, disconnect the micro USB charging
cable, plug it in again, and retry. Charging the battery fully may take up to 2-3 hours.

2-3

Answer/End button

,

Once the devices are paired, the speaker will make a voice prompt and the
LED light will flashing blue every two seconds. These devices will remain paired
and automatically connect to one another whenever they are in range and
both active.

***

(If no device is successfully paired, the speaker will be turn off in approximately 5 minutes).

Answer/End Calls

Answer a call: Press Answer / End button to pick up call and press again to end call.
Reject a call: Press and hold Answer / End button to reject call.
Redial a cal: Press Answer / End button twice to re-dial the last number you called.

AUX-IN

Connect the 3.5mm plug of included 3.5 to 3.5mm audio cable into the AUX INPUT port: connect
the other end of 3.5mm plug to the audio device, then the speaker will change to Auxiliary input
mode automatically, Press and hold “<-” and “+>” to change the volume. In the Auxiliary input
mode, you cannot change tracks on the speaker, you’ll need to control that on your device.