G KINDLY ELECTRONIC KDL BT1811 User Manual

BLUETOOTH SPEAKER

Bluetooth Speaker
USER MANUAL

Model: BB290, KDL-BT1811

Introduction

Thank you for purchasing the Billboard Bluetooth
Speaker. For best use of this device we recommend
carefully reading this user manual and keeping it for
your records

Package Contents

a. Bluetooth Speaker
b. USB charging cable
c. Instruction manual
d. AUX 3.5 mm cable

a.

c.

d.

Device Guide

≥85

Pairing The Speaker

1. Press ON/OFF button to power on. The indicator LED will
light and indicate it is ready to pair.

2. Activate the Bluetooth™ feature on your device, and set
the device to discovery mode to search for wireless
audio devices. (See the User Manual for your device)

3. Tap the Speaker on your device displayed as BB-BT-SP.
(if pass code is requested enter 0000)

* Once the Speaker has been paired, it will automatically

connect with your device.

Device Safety

·

Your Bluetooth Speaker has an internal rechargeable
battery. Improper usage may result in the Speaker
becoming hot, igniting or bursting and causing injury
if exposed to conditions of abuse.

· Do not disassemble, throw away or damage the
Bluetooth Speaker.

Store the Bluetooth Speaker in a dry place, keeping

·
it away from damp corrosive materials and

environments such as salt air.

· Keep the Wireless Speaker away from direct sunlight,

Bluetooth Speaker inside a car during hot weather.
Remember a closed car acts as a green house allowing
the inside to reach high temperatures.

·

The Bluetooth Speaker is not a toy. Please keep
it out of the reach of young children.

·
Please do not discard the Wireless Speaker.

Consult your local waste collection agency
for proper disposal or recycling methods.
You may also contact "Call2Recycle"
at 877-273-2925 or online at
"call2recycle.org" for a battery
recycling drop off location near you.

Charging The Battery

1. Plug the charger cable into the charge port.

2. Connect the charger to a USB power source. The red
indicator light will display during charging. If charging
does not start, disconnect the charger plug it in again,
and retry. Charging the battery fully may take hours.

3. When the battery is fully charged, the red indicator light
will turn off. Disconnect the charger from the USB
power source and the Speaker. The fully charged
battery has power for hours of music time.

Battery Information

Your Speaker is powered by a rechargeable battery. The
full performance of new batteries is achieved only after two

to three complete charge and discharge cycles. The
battery can be charged and discharged hundreds of times,

but it will eventually wear out.

· Do not leave a fully charged Speaker connected to a
charger, overcharging may shorten its lifetime. If left
unused, a fully charged Speaker battery will lose its
charge over time.

· Never use any charger that is damaged.

· Leaving the device in hot or cold places will reduce the
capacity and lifetime of the batteries. Optimal
temperature for the batteries is between and .
A device with a hot or cold batteries may not work
temporarily, even when the batteries are fully charged.

·
Batteries may also explode if damaged. Always dispose
of batteries according to local regulations. Please
recycle. Do not dispose as household waste.

Technical Support

[e-mail] or call [phone]

© 2018 Billboard IP Holdings, LLC. All rights reserved.
Billboard ,the Billboard logo, HOT 100 and associated
characters,trademarks and design elements are owned
and licensed by Billboard IP Holdings, LLC.

Bluetooth is a registered trademark of Bluetooth SIG
All other trademarks are property of their respective companies.

FCC Information FCC ID: 2ALR9-KDL-BT1811

This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this
device must accept any interference received; including
interference that may cause undesired operation.

Federal Communications Commission (FCC) Statement
This Equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a

residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,

There is no guarantee that interference will not occur in a

particular installation. If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by
one or more of the following measures:

· Reorient or relocate the receiving antenna.

· Increase the separation between the equipment and
receiver.

· Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

· Consult the dealer or an experienced radio/TV/

technician for help.

expressly approved by the party responsible for
compliance could void the user authority to operate the
equipment.Tested to comply with FCC standard.

FOR HOME OR OFFICE USE.

Warning:

This equipment complies with FCC RF radiation exposure
limits set forth for an uncontrolled environment. This
device and its antenna(s) must not be co-located or
conjunction with any other antenna or transmitter.

Limited Warranty

purchaser that this product, when shipped in its original container to
the original purchaser, will be free from defective workmanship and
materials for one year and agrees that it will, at its option, either
repair the defect or replace the defective product or part thereof at
no charge to the purchaser for parts or labor for the time periods
described.

This warranty does not apply to any appearance items of the
product nor to the additional excluded item(s) set forth below nor to
any product the exterior of which has been damaged or defaced
which has been subjected to misuse, abnormal service or handling

limited warranty described herein is in addition to an applicable law.

ALL IMPLIED WARRANTIES INCLUDING THE WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR USE ARE LIMITED TO THE
PERIOD FROM THE DATE OF ORIGINAL PURCHASE SET FORTH
BELOW. Some states do not allow limitations on how long an implied
warranty last, so the above limitation may not apply to you. Neither
the sales personnel of the seller nor any other person is authorized to
make any warranties other than those described herein or to extend
the duration of any warranties beyond the time period described
herein on the behalf of ESI Cases and Accessories.

The warranties described herein shall be the sole and exclusive

warranties granted by ESI Cases and Accessories and shall be the
sole and exclusive remedy available to the purchaser corrections of
defects, in the manner and for the period of time described herein,

shall constitute complete fulfillment of all liabilities and responsibilities

of ESI Cases and Accessories to the purchaser with respect to the
product and shall constitute full satisfaction of all claims, whether

based on contract negligence, strict liability or otherwise. In no
event shall ESI Cases and Accessories be liable or in any way
responsible, for any incidental of consequential economic or
property damage. Some states do not allow the exclusion of
incidental or consequential damages, so the above exclusion may
not apply to you. THIS WARRANTY GIVES YOU SPECIFIC LEGAL

RIGHTS. YOU MAY ALSO HAVE OTHER RIGHTS, WHICH VARY

FROM STATE TO STATE.

This warranty does not cover cables that have become frayed,
cracked, or broken from use. The user should immediately replace
this, or any, charge cable that has become frayed, cracked, or
broken, as it may constitute a serious safety risk, including
electrocution, if it is continued to be used.

Send device with the product to:

ESI Cases and Accessories

*Enclose proof of purchase and $11.95 for Shipping and Handling.