GJD D-TECT X REPEATER GJD 397 Installation Manual

-1-

D-TECT X REPEATER

GJD 397 Repeater

Package Contents

Package Contains:

• 1 x D-TECT X Repeater & 1A PSU in IP65
Housing

• 1 x Installation Manual

Introduction

The D-Tect X Repeater can be used to extend the
range of a D-Tect X detector, or to boost signal in a poor
reception area.

D-Tect X Repeater

The D-Tect X Repeater must be placed within 500
metres line of sight between the D-Tect X detector(s)
and D-Tect X Receiver(s). The unit will repeat all signals
from D-Tect X detectors within range and as such does
not require any programming to function.

Specifications

Range 500m (line of sight)

Tamper Switches Front and rear tamper switch-

es: case open and removal
from wall

Wireless Frequency 868MHz

Current 23mA (12V nominal)

Operating Temperature -10 to +50 Centigrade,

Conformal coated electronics
for increased stability

Housing High impact, ame retardant,

UV stabilised Polycarbonate

Protection Rating IP55

Dimensions W210mm x H180m x D79m

Weight 750grams NET, 880grams

GROSS

Power Supply Module

The GJD Power Supply Module provides a 12 VDC
output from a 230 VAC input that enables the D-Tect X
Repeater to be conveniently installed with easy access
to a mains supply.

Installation

• The Power Supply Module requires a 230 VAC­supply on the LIVE input and a neutral on the N
connection.

• An EARTH connection is also provided for the
termination of the earth conductor. Ensure this
connection is securely made.

• Connect the positive and negative terminals of the
12 VDC output to the corresponding inputs of the
D-Tect X Repeater.

IMPORTANT SAFETY REQUIREMENTS

• The Power Supply Module MUST be installed and

maintained by suitably qualied engineers and the

installation MUST comply with all relevant code of
practice and regulations.

• All mains supplies to the module MUST be via a
Residual Current Device (RDC) and an overload
protection device.

• All mains supplies to the module MUST be
disconnected before removing the cover.

Specifications

Mains Supply Input 230 VAC, 50 Hz

12 VDC Output 12 VDC, 1A

5 VDC Output 5 VDC, 0.1A

Operating Temperature -10 - +50 degrees centigrade

Engineer Notes

Technical: 01706 363990
Sales: 01706 363998
Fax: [phone]
Email: [e-mail]