User Guide_Hardware
1
Component
GVCI component
Unlock Button
External Port
Bluetooth Button
User Guide_Hardware
II connector
(Optional)
0MHz
256
2
GVCI
◈GVCISpecification
Specification
Unlocks GVCI from OBD-
Communication port for Tablet PC
Enables Bluetooth mode
Item
Micro Controller
System Memory
Operating Voltage
Specifications
ARM 32-bit Cortex™-M4 / 18
Flash Memory 2Mbyte / SRAM
7~30VDC
KByte
Vehicle Communication Interface)
Color Description
Connection in Ready status
]:
User Guide_Hardware
) : Wireless LAN Mode
) : USB Mode
℉
℉
~ 86
~ 131
℉
Diagnosis Function / Flight Record Function
pin Connection
GVCI Is not connected with
Single Speed
2000
/J1587,J1850(VPWM,PWM)
3
Temperature
Relative
Humidity
Operating Mode
Current Consumption
Housing
Dimension
Weight
Interface
Item
Wire Protocol
Operating
Storage
Operating
Storage
-10℃ ~ 50℃ (14℉ ~ 122℉
-10℃ ~ 55℃ (14℉ ~ 131℉
-20℃ ~ 80℃ (-4℉ ~ 176
Noncondensing @ 0℃ ~ 10℃ (32
95%RH @ 10℃ ~ 30℃ (50℉
70%RH @ 30℃ ~ 55℃ (86℉
Noncondensing @ -20℃ ~ 80℃ (-4
Typical 100mA @12V
ABS
58 X 74 X 36 mm
90g
Specifications
USB 2.0 Full Speed via 30-
)
~ 50℉)
℉)
℉)
~ 176℉)
Wireless Protocol
Indication Lamps
Input Devices
GVCI (G-scan tab
Item
CAN
K-Line/L-Line
Commercial Vehicle
Data/Control Line
◈GVCI LED
[Blue on]:
Bluetooth 2.1 (2.4GHz )
1 LEDs(Front)
Input key
Specifications
CAN (High Speed, Low Speed,
ISO-9141, ISO-9141-CARB, KWP-
SAE-J1708
Melco Pull-Down
–
)
G-scan Tab
[Blue flashing
GVCI is connected with G-scan Tab
[Green flashing]:
Vehicle communication in process
How to connect with vehicle
Connect GVCI connector with OBD
4
◈
User Guide_Hardware
-II port of vehicle.
Appendix
Changes or modifications not expressly approved by the party responsible for
complianceCould void the user
This device complies with part 15 of the FCC Rules.Operation is su
following two conditions:
This device may not cause harmful interference, and
this device must accept any interference received, including interference that may
causeundesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
User Guide_Hardware
s authority to operate the equipment.
5
’
(1)
(2)
NOTE:
bject to the
protection against harmful interference in a residential installation. Th
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful
guarantee that interference will not occur
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to
more of the f
ollowing measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
perienced radio/TV technician for help.
Indication of any restrictions of use
This equipment was restricted to indoor use.
Indication of the countries where the equipment is intended to bo used
This equipment may be operated in
LU, MT, NL, PL, PT, SK, SI, ES, SE, GB, IS, LI, NO, CH, BG, RO, TR
This product is CE marked according to the provision of the R
Here by G.I.T co., Ltd.. declares that this product in compliance with
and other relevant provisions of Directive
WEEE (Waste Electrical and Electronic Equipment) symbol shown in [Figure 1] is indicated on the
back of the VCI main module, VMI main module, and
Please follow the regulation guide for disposal of Waste Electrical and Electronic Equipment. Use
caution disposing of the Trigger module; it contains a lithium battery. Users must follow the
regulations when replacing or discarding this b
is equipment generates,
to radio communications. However, there is no
in a particular installation. If this equipment does
try to correct the interference
FR, DE, GR, HU, IE, IT, LV, LT,
the essential requirements
6
connected.
Consult the dealer or an ex
User Guide_Hardware
interference
by one or
AT, BE, CY, CZ, DK, EE, FI,
ED( 2014/53/EU).
2014/53/EU
Trigger module.
attery.
Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other
European countries with separate collection systems)
This symbol on the product or on its packaging indicates that this product sh
household waste. Instead it shall be handed over to the applicable collection point for the
recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly,
you will help prevent potential negative
which could otherwise be caused by inappropriate waste handling of this product. The recycling
of materials will help to conserve natural resources. For more detailed information about recycling
oduct, please contact your local city office, your household waste disposal service or the
shop where you purchased the product.
User Guide_Hardware
all not be treated as
consequences for the environment and human health,
7
Fig. 1. WEEE Symbol
of this pr
Loading...