Gispen Zinn series User Manual

USER MANUAL

2015.A4D

ZINN

Move the lever up to activate
the gas spring.

SEAT HEIGHT ADJUSTMENT

Adjust the seat height with your upper

and lower leg angled at 90°

to 100°. This position will result in

the least possible pressure on the

upper legs which allows for a better
blood circulation.

SEAT DEPTH ADJUSTMENT

Adjust the seat depth to a space

approximately the size of a fist

between the seat and the backs of the

knees. This position will result in the

least possible pressure on the upper

legs which allows for a better blood

circulation.

Push the button to move the
seat forward or backward
for a longer or shorter seat
surface.

LUMBAR SUPPORT

ADJUSTMENT

Adjust in height to where the lumbar

support is on the same level as your

belt (just slightly below the hollow of

your back and just above your pelvis).

This ensures the right support of the

lower back.

Move the lumbar support on
the rear of the backrest up
or down for the right lumbar
support.

AUTOFIT SYNCHRONOUS MECHANISM

The use of the autifit synchronous mechanism stimulates sitting in a dynamic way. It

prevents static strain and helps to prevent complaints which are caused by sitting for long

periods of time. Therefore we recommend always setting the chair in active mode.

The autofit synchronous mechanism can be set in three dynamic modes.

S: small rearward movement

M: medium rearward movement

L: large rearward movement

Starting point: Back is fi xed in upright position (lever fully pull out)

• Activating dynamic mode S:

Push the lever one position inside

• Activating dynamic mode M:

Push the lever two positions inside

• Activating dynamic mode L:

Push the lever three positions inside

FINE TUNING BACK

PRESSURE AUTOFIT

SYNCHRONOUS

MECHANISM

Pull the lever on the front

of the mechanism forward.

Turn clockwise for more
pressure.

Turn counterclockwise for less
backpressure.

Push the lever back

Optional, not for every model available!

2015.A4D

ZINN