Dimmer push-button/2-way low voltage
Order No. : 2262 00
Operating instructions
1 Safety instructions
Electrical equipment may only be installed and fitted by electrically skilled persons.
Serious injuries, fire or property damage possible. Please read and follow manual fully.
Danger of electric shock. Always disconnect before carrying out work on the devise or
load. At the same time, take into account all circuit breakers that supply dangerous
voltage to the device or load.
Danger of electric shock. Device is not suitable for disconnection from supply voltage.
Fire hazard. For operation with inductive transformers, each transformer must be fused
on the primary side in accordance with the manufacturer's instructions. Only safety
transformers according to EN 61558-2-6 may be used.
Do not connect any LED or compact fluorescent lamps that are not specifically suitable
for dimming. Device can be damaged.
Do not connect any lights with integrated dimmers. Device can be damaged.
These instructions are an integral part of the product, and must remain with the end
customer.
2 Device components
Figure 1: Device components
(1) Dimmer
(2) Frame
(3) Central plate
(4) Control button
(5) Fuse holder
(6) Measuring points for voltage test
(7) Release lever for plug terminal
(8) Setter, minimum brightness
1/6
32534532 20.12.2013
Dimmer push-button/2-way low voltage
10499194 I00
3 Function
Intended use
- Switching and dimming of incandescent lamps, HV halogen lamps as well as dimmable
inductive transformers with halogen or LED lamps.
- Switching and dimming dimmable HV-LED lamps or compact fluorescent lamps.
- Installation in appliance box according to DIN 49073.
i No mixed-load operation of HV LED and compact fluorescent lamps. All other specified
load types can be used in mixed-load operation.
i No operation with Tronic transformers.
i HV-LED and compact fluorescent lamps generate high pulsed currents, when they are
operated in the leading edge phase control. Depending on the design and power rating of
these lamps, the connected load of the specified values could vary.
Product characteristics
- Phase cut-on dimming principle
- Short-circuit protection through fine-wire fuse
- Electronic over-temperature protection
- Changeover switch possible in combination with two dimmers
- Control output A (9) (Figure 2) to output the switching state of the device for automatic
power disconnection or relay
i Do not use control output A as a load output.
i Flickering of the connected lamps due to undershoot of the specified minimum load or
through centralised pulses from the power stations and soft humming of the device due to
the radio interference suppressor. These are not device faults.
4 Operation
Switch light
o Press the control button.
Adjust the brightness
Light is switched on.
o Turn the control button in the clockwise direction.
The light gets brighter up to maximum brightness.
o Turn the control button in the anti-clockwise direction.
Light gets darker to minimum brightness.
5 Information for electrically skilled persons
5.1 Fitting and electrical connection
DANGER!
Electrical shock when live parts are touched.
Electrical shocks can be fatal.
Before working on the device, disconnect the power supply and cover up live
parts in the working environment!
32534532 10499194 I00 20.12.2013
2/6
Dimmer push-button/2-way low voltage
Loading...