Gira Powernet Switchactuator 2fold, Powernet Switchactuator 4fold Installation Instructions Manual
GIRA
Info
Powernet Switchactuator 2fold/4fold
Installation Instructions
Powernet Switchactuator 2fold Art. Nr.: 0430 00
Powernet Switchactuator 4fold Art. Nr.: 0433 00
230 V AC~
L
N
50 Hz
23
1
µ
56
4
c
NN L L
A1
A2
System Information
This device is a product of the GIRA-Powernet
EIB system and complies with EIBA directives.
Detailed technical knowledge obtained in instabus or
GIRA-Powernet
®
EIB training courses is a prerequisite to proper understanding.
The functionality of this device depends upon the
software. Detailed information on loadable software
and attainable functionality may be taken from the
manufacturer’s ETS2 product database as well as
from the GIRA-Powernet
®
EIB controller database.
Planning, installation and commissioning of the unit
is done by means of the ETS2 software, Ver. 1.1 or
later, as well as by the GIRA-Powernet
®
troller.
®
EIB con-
230 V AC~
L
N
50 Hz
23
1
µ
56
4
A2
A1
d
Function
The Switchactuator allows two (or, respectively,
e
four) groups of loads to be switched independent of
each other.
Connection
Establish electrical connection as shown in the
opposite illustration.
c
NN L L
89
7
A3
µ
11 12
10
A4
d
e
Where:
c GIRA-Powernet
®
EIB connection.
d Programming key.
e Programming LED
The connection of different external leads to the
channels is admissible.
Indications of danger
Caution! The installation and assembly of
electrical equipment may be carried out only by
a skilled person. Do not connect any loads/types
of load other than specified.
Subject to change without notice.
Powernet Switchactuator 2fold/4fold 03/99 Page: 1 of 3
GIRA
Info
Powernet Switchactuator 2fold/4fold
Installation Instructions
Technical Data
Supply
Mains voltage: 230 V AC (sine wave)
Mains frequency: 50 Hz
Power consumption at no-load: ca. 2 VA
Connection
Powernet: screw terminals
0,5 - 4 mm², unifilar
0,5 - 2,5 mm² finewire
0,5 - 2,5 mm² finewire with core end bush
Load circuit: Plug terminals
0,5 - 2,5 mm², unifilar
0,5 - 2,5 mm² finewire with pin cable socket
0,5 - 1,5 mm² finewire with core end bush
max. Switching power
incandescent lamps: 1000 W
HV halogen: 1000 W
NV halogen
(depending on ballast): 200 to 500 VA
Fluorescent lamps
non-compensated: 500 W
dual circuit: 1000 W
parallel compensated (C ≤ 14µF): 2 x 58 W / 3 x 36 W / 6 x 18 W
Terminal current: 10 A
Ambient temperature: -5 °C to +45 °C
Type of protection: IP 20
Switchactuator 2fold
Build-in width: 45 mm (2,5 PU)
Weight: 185 g
Switchactuator 4fold
Build-in width: 63 mm (3,5 PU)
Weight: 250 g
Powernet Switchactuator 2fold/4fold 03/99 Page: 2 of 3
Loading...