GIRA
Info
KNX IP-Router
Installation Instructions
KNX IP-Router 9/07 Page 1 of 4
System information
This device is a product of the Instabus-KNX system
and complies with KNX directives.
Detailed technical knowledge obtained in Instabus
training courses is a prerequisite to proper understanding.
The functionality of this device depends upon the software.
Detailed information on loadable software and attainable functionality as well as the software itself can be
obtained from the manufacturer’s product database.
Planning, installation and commissioning of the unit is
effected by means of KNX-certified software.
An updated version of the product database and the
technical descriptions are available in their latest version on our Internet homepage.
Function
Description
• Rail-mounted device for installation in distributions
• Interconnection of KNX lines via local area data
networks (LAN) based on the use of the IP protocol
(IP = Internet Protocol)
• Use as line / area coupler (filter tables)
• Interconnection of KNX devices with PCs or other
DP devices via IP (use as data interface)
• Power supply via external power supply unit
(accessories)
• Transmission of KNX system failure message to
the PC
• Electrical separation between KNX and IP network
KNX IP-Router
Order no.: 1030 00
Safety instructions
Electrical equipment must be installed and fitted
by qualified electricians only.
Failure to observe the instructions may cause
damage to the device and result in fire and other
hazards.
Supplying the IP router with power from the KNX
unit (‚non-choked‘ output) is not permitted. Risk
of grounding the safety extra-low voltage of the
KNX system.
Use safety transformers in acc. with EN
61558-2-6 or doorbell transformers in acc. with
EN 61558-2-8.
These instructions are part of the product and
must be left with the customer.
i
Depending on application, access requirements, data security and data volume it may
be advisable to install independent network
paths for individual services using the IP network.
GIRA
Info
KNX IP-Router
Installation Instructions
KNX IP-Router 9/07 Page 2 of 4
Status LED (Figure 1)
(1) LINE (yellow) data reception on KNX line
(2) RUN (green) ready for operation
(3) LK (green) Ethernet link signal (lit up during
active connection with the IP net-
work)
(4) RX (yellow) Ethernet receive signal (lit up/
flashing on reception of valid IP
telegrams)
(5) TX (yellow) Ethernet transmit signal (lit up/
flashing during active transmission to the IP network)
Information for qualified electricians
Fitting and electrical connection
Fitting in fixed installations indoors, in dry rooms,
power distributions or small housings with DIN rail.
Observe the temperature range. Ensure sufficient
cooling.
• Install by snap-fastening on mounting rail in acc.
with EN 60715. Mounting position see figure 2.
• Connect the external power supply to terminal (7).
Recommendation: Use white/yellow terminal.
• Connect the KNX line by means of the black/red
bus terminal (8).
• Connect the IP side with RJ45 connector plugged
into RJ socket (6).
DANGER!
Risk of electric shock on accidental contact with live parts in the fitting environment.
Electric shocks can be fatal.
Before fitting, disconnect the supply voltage and cover up live parts in the working environment.
Loading...