GIRA
Info
LED-Clock/Alarm Clock/Thermometer 230 V~
Instructions for Installation
LED-Clock/Alarm Clock/Thermometer 230 V~ Art. Nr.: 0096 ..
Function
The LED Clock/Alarm Clock/Thermometer has the following functions:
• Alternating display of temperature and time, or display of temperature or time.
• 2 different alarm times can be set.
• The light intensity of the LED display is adjustable to 2 levels.
• Reserve power from the built-in lithium battery.
• Temperature adjustment.
Safety Note
• Caution: Installation and assembly of electrical devices may only be carried out by
electrical specialists.
• Caution! Button cells do not belong in the hands of children. Immediately seek the
assistance of a physician if button cells are swallowed.
• Do not immerse button cells in water, and do not throw these into a fire.
• Only replace a button cell with an identical type.
• Immediately remove dead button cells and dispose of in an environmentally friendly manner.
Site of Installation
Only install in closed rooms.
In order to avoid damage and inaccurate reading, you should not expose the thermometer to high
humidity, extreme temperature (in combination with a dimmer for example), vibration and shock.
Installation
The LED Clock/Alarm Clock/Thermometer is mounted in a 60 mm flush-type switch box.
For connection: see illustration c.
Caution: Only insert the batteries after connection to the supply system (see battery change).
L
N
N
L1
Illustration c Illustration d
AC 230 V
LED-Clock/Alarm Clock/Thermometer 230 V~ 03/99 Page 1 of 4
GIRA
Info
LED-Clock/Alarm Clock/Thermometer 230 V~
Instructions for Installation
Battery Change
The end of the battery charge is shown by a point (see illustration e) in the LED display.
1. To change the battery, remove the cover and open the battery drawer (see illustration d).
2. Replace the old battery with a new one of the same type (lithium button cell CR1025) while paying
attention to the correct polarity.
The battery is laid in the drawer with the + pole up (see illustration d).
3. Close the drawer and place the cover on the support ring again.
4. Do not dispose of batteries in normal household waste. Give the batteries to a suitable collection
point.
LED Display
BAT.
6
H
1
Illustration e
5
M
2
3
1. Button: hours/temperature correction ↓
2. Button: brightness display/switch off alarm
4
signal/display change on/off
3. Button: minutes/temperature correction ↑
4. Display: alarm time 1 on/off
5. Display: alarm time 2 on/off
6. Display: battery end
Display Alternation On/Off
You can choose from alternating, time, or temperature display.
Press briefly on the button
Example: The LED Clock/Alarm Clock/Thermometer constantly alternates between time and
temperature. You want only the time to be displayed. Wait until the time appears in the
LED display and then press 1 x briefly on the button
displayed.
Press 1 x briefly on the button
and time again.
1 x to pause the display or to start the alternating display.
Alternating
Display
00:00
°C
press 1 x briefly
00:00
Time
Display
Button
and the LED display alternates between temperature
Button
press 1 x briefly
°C
Temperature-
Display
. The time will now be constantly
Setting the time
1. Wait or change (see: Display Alternation On/Off) to the time display.
2. Press the button H to set the hours and the button M for the minutes. To advance quickly, hold
button H or M down.
LED-Clock/Alarm Clock/Thermometer 230 V~ 03/99 Page 2 of 4
Loading...