Ginger 1141-42, 1541-42, 1741-42, 1941-42 Installation Manual
Complement
your purchase
with these
fine accessories
ID1141.PDF 4.19.06
also from
Lights
Mirrors
Towel Bars
Bud Vases
Towel Rings
Soap Dishes
Hotel Shelves
Tumbler Holders
Toilet Tissue Holders
Shower Curtain Rods
Soap & Bottle Baskets
MIRROR
STATIONARY & WITH
TILT MECHANISM
INSTALLATION
INSTRUCTIONS
for
CHELSEA
CANTERBURY
SUSSEX
Cabinet Hardware
Toiletry Shelves
Grab Bars
Hooks
460-N Greenway Industrial Drive Fort Mill SC 29708
gingerco.com
SYNCHRO
INSTALLATION INSTRUCTIONS FOR MIRRORS
1141-42
1741-42
•
1541-42
•
1941-42
Chelsea, Canterbury, Sussex & Synchro TILTING MIRROR
TILTING MIRROR
INSTALLATION:
1. Determine location of
mirror on wall.
2. Position the mounting
bracket as illustrated.
The bracket should be
level and in the center
of the desired mirror
location. Mark the
location of the mounting
bracket screw holes
on the wall.
3. Position the tilting
mechanism as
illustrated. Mark the
location of the
mounting screw holes
on the wall.
4a. For drywall installation:
Using a No. 2 Phillips
screwdriver, push and
turn zinc anchors in a clock-wise direction until flush with wall surface. If
wood cross bracing or a stud is present, pre-drill a 1/4" (6mm) diameter
hole and install small plastic anchor in place of the zinc anchor.
4b. For tile or solid wall installation:
Drill 1/4" (6mm) on marks made in Step 1. Insert plastic wall anchors
and tap flush with wall.
5. Position the mounting bracket and the tilting mechanism over the
anchors and install screws.
6. Swing the tilting mechanism to the vertical position (flush against the wall.)
Chelsea, Canterbury, Sussex & Synchro STATIONARY MIRROR
STATIONARY MIRROR
INSTALLATION:
Determine location
1.
of mirror on wall.
2. Position the mounting
bracket as illustrated.
The bracket should be
level and in the center
of the desired mirror
location. Mark the
location of the mounting
bracket screw holes
on the wall.
3a. For drywall installation:
Using a No. 2 Phillips
screwdriver, push and
turn zinc anchors in a
clock-wise direction
until flush with wall
surface. If wood cross
bracing or a stud is
present, pre-drill a 1/4"
(6mm) diameter hole and
install small plastic anchor in place of the zinc anchor.
3b. For tile or solid wall installation:
Drill 1/4" (6mm) on marks made in Step 1. Insert plastic wall anchors
and tap flush with wall.
4. Position mounting bracket over the anchors and install screws.
5. Slide mirror down wall until cross rod is supported by the mounting bracket.
Tools needed:
Pencil, Tape measure, Phillips Screwdriver, Drill and Level.
7. Slide mirror down wall until cross rods are engaged in tilting mechanism
and mounting bracket. The bracket, not the tilting mechanism, should
support weight of mirror position. Adjust mounting bracket or tilting
mechanism if necessary.
To clean, use
warm water only.
No chemical
cleaners.
Loading...