PROFESSIONAL MEDICAL PRODUCTS
FFP3 NR D DEFENCE MASK
USE INSTRUCTIONS
1. Failure to follow all instructions and limitations can seriously reduce
the effectiveness of this respirator and could lead to illness, injury or
death.
2. A properly selected respirator is essential. Before occupational use,
the wearer must be trained by the employer in the correct use of
the respirator in accordance with applicable safety and health standards.
3. This product does not supply oxygen. Use only in adequately venti-
lated areas containing sufcient oxygen to support life.
4. Discard the respirator and replace with a new one if:
a. excessive clogging of the respirator causes breathing difculty;
b. the respirator becomes damaged.
5. Leave the contaminated area if dizziness, irritation or other Distress
occurs.
6. Keep respirators in the display box away from direct sunlight until
use.
7. User’s must be t tested prior to wearing this respirator either qualitatively or quantitatively according to 29CFR 1910.134.
8. Before wearing the mask respirator users must check whether there
is crack or spot around the welding spot, if yes, the mask must be
discarded at once and can not be used again.
9. Keep the unused respirators in their closed box and store in a dry
non-contaminated area between +5°C and +38°C. Storage life is 3
years from date of manufacture.
USE LIMITATIONS
1. Do NOT use the respirator or enter or stay in a contaminated area
under the following circumstances:
a. atmosphere contains less than 19.5% oxygen;
b. if you smell or taste contaminant;
c. for protection against gases or vapour;
d. contaminants or their concentrations are unknown or immediate-
ly dangerous to life or health;
e. concentrations of contaminants exceed maximum use concen-
trations in applicable OSHA standards or applicable government
regulations or 50 times the PEL
whichever is lower;
f. for sandblasting, paint-spray operations and asbestos;
g. use in explosive atmospheres.
2. Do NOT modify or misuse the respirator.
3. Do NOT use the respirator with facial hair or any other conditions
that may prevent a good face-seal.
Warning:
This respirator helps protect against certain particulate contaminants
but does not eliminate exposure to or the risk of contracting disease or
infection. Misuse may result in sickness or death.
FITTING INSTRUCTIONS
1. Place ngers inside the respirator. Bend the nose clip around ngers
to form nose shape.
2. Hold the respirator in position over the nose and mouth with the
headstraps around the back of the hand. Pull lower strap over the
head and t around the back of the neck.
3. Pull the upper strap over the head positioning it just above the ears.
4. Using both hands, form the nose clip around the nose and shift the
headstraps to ensure a positive face seal.
5. Seal check
• To test the t of a respirator without an exhalation valve, cup both
hands over the respirator and exhale sharply.
• To test the t of a respirator with an exhalation valve, cup both
hands over the mask and inhale sharply. A negative pressure
should be detected inside the respirator.
• If air ow is felt in the nose area, re-adjust/tighten the nose clip.
• If air ow is felt around the edges of the respirator, re-position the
respirator/headstrap to achieve a better t.
(Permissible Exposure Limit),
ENGLISH
6. Change the mask immediately if breathing becomes difcult or mask be-
comes damaged or distorted.
7. Change the respirator if a proper face seal can not be achieved.
8. Careful observance of these instructions is an important step in safe respirator use.
1
3
2
4
Index of Symbols
Non sterile
Manufacturer Date of manufacture
Product code Lot number
Expiration date
Humidity limit Temperature limit
Disposable device,
do not re-use
Consult instructions
for use
Keep away from
sunlight
Personal protective
equipment compliant
with EU regulation
2016/425
Loading...