Giga Tent MT 011 User Manual

Model # MT010

Model # MT011

Tekman 1

7’ W x 3.5’ x 42” H

Owner’s Manual

Tekman 2

7’ W x 5’ x 48” H

IMPORTANT

We strongly suggest setting up your new tent before initial use to
insure that all parts are present and to familiarize yourself with the
tent’s assembly. This will have a great effect on how well enjoy your
product and experience.

For questions or concerns call Gigatent at our Toll Free Number:
877-836-8701 Monday-Thursday 9am-5pm EST, Friday 9am-12pm EST or email us at [e-mail].
For replacement parts, please login to our website at gigatent.com and click the link “replacement parts”.

IMPORTANT

Though we take very seriously every tent perform according to our
stringent requirements, we strongly recommend all tent seams be
sealed using a water based sealer to avoid water leaking into tent from
seams. For best results, seal seams from outside of tent.

ASSEMBLY INSTRUCTIONS

Frame Parts

Fiberglass Poles

Poles (x2)

Stakes

x11

Step 1- TENT SET UP

To prolong the life of your tent floor we suggest using a ground cloth cut slightly smaller than the floor of your tent and that you select
a clean level area for your campsite.

1) Spread the tent body out on the ground.

2) Fully open both of the poles.

3) Carefully thread each pole through the pole sleeves located on top of the roof of tent (Figure A).

5) Starting with one pole, insert the pole end into the corner strap grommet located on bottom corner of tent. Be sure to insert end into
the grommet closest to tent (Figure B). Bend pole and insert opposite end into the long side adjacent corner of tent (Figure C).
NOTE: unlike many dome tents which cross the poles at the center top, this tent has relatively parallel pole sleeves construction.
Repeat for other pole on the other sleeve and corners. Your tent should now be erect.

6) Attach all of the pole clips to the poles (Figure D).

7) Tie the straps onto the poles (Figure E).

8) Stake the tent down (Figure F).

TENT SET UP DIAGRAM

A

B

D

E

F

C

Step 2- ATTACHING THE RAIN FLY

9) Open the rain fly and drape it over the tent body right side up. Ensure fly door is facing tent door.

10) Tie the inside of fly the poles (Figure G).

11) Attach the bungee cords of fly to the grommets at the bottom of each corner of tent using the hook provided (Figure H).

12) Pull door of fly out (away from tent body) to create the vestibule and stake down (Figure I).

ATTACHING RAIN FLY DIAGRAM

H

G

I

Step 3- EXTRA STABILITY IN WINDY CONDITIONS

13) In windy conditions use the extra stakes and guylines to add extra stability (Figure J).

EXTRA STABILITY DIAGRAM

Stake placement

40

Tent

J