Third-party brands and names are the properties of their respective owners.
Notice
Please do not remove any labels on this graphics card. Doing so may void the warranty of this card.
Due to rapid change in technology, some of the specifications might be out of date before publication of this this manual.
The author assumes no responsibility for any errors or omissions that may appear in this document nor does the author
make a commitment to update the information contained herein.
Rovi Product Notice:
This product incorporates copyright protection technology that is protected by U.S. patents and other intellectual property rights.
Use of this copyright protection technology must be authorized by Rovi Corporation, and is intended for home and other limited
viewing uses only unless otherwise authorized by Rovi Corporation. Reverse engineering or disassembly is prohibited.
performance by allowing the graphics processing unit (GPU) to dynamically share the
available system memory. The total effective VGA memory differs depending on system
memory.
(Note1)
• Integrated with 1 GB/512MB GDDR5 memory
• Supports DirectX 11
• Supports CrossFireX
•Supports 1 Dual-Link DVI-I connector
•Supports 1 D-Sub connector
•Supports 1 HDMI connector
TM
HD 5670 Graphics Processing Unit (GPU)
TM
technology which enables graphics card
TM
1.2. Minimum System Requirements
• Hardware
-Intel® Pentium® 4/CoreTM 2 or AMD Athlon
-1 GB or more of system memory for best performance
-Optical drive for software installation (CD-ROM or DVD-ROM drive)
-A power supply that provides at least 400-watt is required. The power supply should be
with a known brand and certified to conform to safety regulations. (For the list of certified
power supplies, go to http://ati.amd.com/certifiedpsu.)
• Operating System
-Windows® 7
-Windows® Vista
-Windows® XP with Service Pack 2 (SP2)
-Windows® XP Professional x64 Edition
TM
/Phenom
TM
• CrossFireXTM Configuration
If you are planning on using this graphics card as part of a CrossFireX system, the following
is required:
-A CrossFireX certified motherboard with two PCI Express x16 slots and correct chipset driver
-A power supply that provides at least 450-watt is required. The power supply should be
with a known brand and certified to conform to safety regulations. (For the list of certified
power supplies, go to http://ati.amd.com/certifiedpsu.)
-Two CrossFire bridge interconnect cables
- 7 -Introduction
(Note 1) The amount of HyperMemory
TM
will only be shown in the Information Tab found in the Catalyst
ControlCenter. Microsoft System Information program in Windows 7 and Windows Vista lists only
amount of videomemory on Display Adapter under Adapter RAM item.
The amount of HyperMemory available under Windows 7 and Windows Vista is calculated using the
followingformula: