GIEC ELECTRONICS GKMP1515 User Manual

10
11
1 2
3 4
5 6
7 8 9
18 19
20 22 21 24 23 25 26
27
12
14
13 15
16
17
28
29
1 Go in and out of Standby
2 Red button. Functionality depends on the application
3 Green button. Functionality depends on the application
4 Sub-titlw
5 Audio
6 Slide Up
8 F1 button. Functionality depends on the application
9 F2 button. Functionality depends on the application
10 Home Button
11 Move left, right, up, down
12 Setup Button
13 Volume Up/Dn
14 Play/Pause
15 Stop
16 Numeric input
17 Change the screen resolution when available
18 Mute
19 Yellow button. Functionality depends on the application
20 Blue button. Functionality depends on the application
21 Zoom out
22 Zoom in
23 Slide left
24 Slide right
25 F3 button. Functionality depends on the application
26 F4 button. Functionality depends on the application
27 Shortcut to the Main Menu
28 Return on level
29 Skip to next file/Skip to previous file
GK-MP1515
FCC Warning Statement: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
RF Exposure Warning Statement: The operating distance between user and this products include its antenna must be no less than 20 cm.
Loading...