Giant Alarm System JJ-MB-06 Operating Instructions Manual

Quanzhou Giant Alarm System Co., Ltd.

Tel:[phone] Fax:[phone]

Web:www.jujiang.net or www.globalsources.com/giant.co or www.jujiang.en.alibaba.com

- 1 -

Motorcycle alarm system operating instruction

(JJ-MB-06 )

1.EnvironmentalAlarm

 Alert Alarm:turn off engine,short press , light flash once,trumpet sounds’bi’once,and

would go into the stata of alert in 3s
A. enviromental warning.,when first touched siren sounds’bi’several times,light flashing at

the same time,to show car has alarm system;

B. scanty alarm.if touched again light would not flash while siren sounds discontinuous,the

engine fail to work automaticully;

 Deterrable alarm: turn off engine ,long press ,siren sound one time direction light

flash once,then flash once again ,3s later enter into alarm state.
A. when first touched,sound discontinuous 5s, light flash at the same time.
B. if touched again light would sound 15s continuous;

2.Emergency alarming

Any attempt to start the engine would cause continuous long rings from the alarm.

3.Anti-hijack

Quanzhou Giant Alarm System Co., Ltd.

Tel:[phone] Fax:[phone]

Web:www.jujiang.net or www.globalsources.com/giant.co or www.jujiang.en.alibaba.com

- 2 -

When the motorcycle is in motion,in available distance press once,the engine will stop
and be immobilized ,the siren will sound for 3s,and the direction light will flash continuously

4.Searching car

Short press on once, siren sounds 6 times, the lights flashing at the same time to show
where the car is.

5.Self-warming automatically,

On the alert ,press on twice,the engine would start to work then ,if it fails to work
because of frozon,please repeat the above operation.

6.Overtake vehicle

When the motercycle is in motion,and you wish to overtake the front vehicle,press

once,the direction righit will flash rapidly and the siren sounds for 15s at the same time as

a warning sigal

7.Remote engine stop

Press once,when the motorcycle is running,the power of electronic lock will be cut off.the
engine will stop working,the siren and direction light have no reaction

8.Receiving or back to the gard state automatically

A. Under the setting state,press once,after sound 3s will back to the setting state

automatically

B. Under the setting state ,Press ,If no further operation in 3s ,siren sounds ‘bi’

once,means back to alarm state automatically

9.Disarming

When alarm on the alert,short press on ,light flash twice and the trmpet sounds ‘bibi’twice,

Alarm resume normal state.

10.Remote control adjust sensitivity

Long press on + at the same time,to enter into the state of adjust ,siren sound once