GetNet GS-118P User Manual

0

Copyright© by Edimax Technology Co, LTD. all rights reserved. No part of this publication may
be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any
language or computer language, in any form or by any means, electronic, mechanical, magnetic,
optical, chemical, manual or otherwise, without the prior written permission of this company

This company makes no representations or warranties, either expressed or implied, w ith respect to
the contents hereof and specifically disclaims any warranties, merchantability or fitness for any
particular purpose. Any software described in this manual is sold or licensed "as is". Should the
programs prove defective following their purchase, the buyer (and not this company, its distributor,
or its dealer) assumes the entire cost of all necessary servicing, repair, and any incidental or
consequential damages resulting from any defect in the software. Further, this company reserves
the right to revise this publication and to make changes from time to time in the contents hereof
without obligation to notify any person of such revision or changes.

The product you have purchased and the setup screen may appear slightly different from those
shown in this Manual. The software and specifications are subject to change without notice.
Please visit our web site www.getnet.com.tw

for the update. All rights reserved including all brand
and product names mentioned in this manual are trademarks and/or registered trademarks of their
respective holders.

FFeeddeerraall CCoommmmuunniiccaattiioonn CCoommmmiissssiioonn IInntteerrffeerreennccee SSttaatteemmeenntt

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

1. Reorient or relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

4. Consult the dealer or an experienced radio technician for help.

FCC Caution

This device and its antenna must not be co-located or operating in conjunction with any other
antenna or transmitter.This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the authority to operate equipment.

CE Mark Warning.

This is a Class B product. In a domestic environment, this product may cause radio interface, in
which case the user may be required to take adequate measures.

1

Thank you for purchasing GetNet Ethernet switch. This high cost-efficiency switch
complies with 10/100-Base-TX standards is the best choice for Small office / Home office
users. Easy install procedures allows any computer users to setup a network environment
in very short time .

Product Package

This package contains the following components:

 One Fast Ethernet Switch
 Manual
 Power Adapter

If any item is missing or damaged, please contact your local resellers for service.

Feature

• Complies with the IEEE 802.3 , IEEE 802.3u standards.

• Provides Store and Forward architecture, full wire speed filtering and forwarding rates.

• Supports Auto-MDI/MDI-X, full/half duplex modes and auto-negotiation.

• Supports flow control: back pressure for half-duplex, IEEE 802.3x for full-duplex mode.

• Automatic source address learning and aging, extensive front-panel diagnostic LEDs.

Front Panel

GS-115P

GS-118P

2