Getemed VitaGuard VG-310 Short instruction

VitaGuard® VG 310 – short instructions

This instruction leaflet does not replace the manual. If you
are not familiar with the manual, the patient’s health may
be at risk. Please take sufficient time to read the manual.

LED flashes
synchronously
with pulse

LED „Alarm“ flashes
red for physiological
and yellow for
technical alarm.

LED “External
power adapter”

<Esc> key for pausing the acoustic
alarm and to exit menus

LED “Rechargeable
battery is loading”

Current value of
the respective
vital function

Currently set
alarm limits

Navigation
keys

<Enter> key
for switching on
and confirming
settings

Summary of steps before monitoring

 Insert the battery or batteries (do not switch on yet!).
 Use the external power adapter to connect VitaGuard® to the

supply network (do not switch on yet!).

 Attach the SpO
 Connect the SpO
 Connect the SpO

sensor to the patient.

2

patient cable to VitaGuard®.

2

sensor to the patient cable.

2

 Switch on VitaGuard®.

Make sure that after the monitor is switched on the indicator lamps
light up briefly and a short sound is emitted by the alarm buzzers.

Check that the alarm limits displayed are the same as those recom­mended by the doctor.

Switching off VitaGuard®

Always switch off VitaGuard® in the manner described here.

1 Press the <Enter> key and keep this pressed: the message Press

Esc key appears.

2 Briefly press the <Esc> key, still keeping the <Enter> key pressed,

and then release both keys.
The switch off command is acknowledged by two short beeps.
Data must be stored before the device finally switches off. For this

reason, VitaGuard® needs about another two seconds after the keys
are released until it switches off completely.