GE
Securit
y
UVD-XP3DNR(-P) Camera
Installation Sheet
EN DE ES FR IT NL PL PT RU TR
2
1
3
4
5
© 2009 GE Security, Inc.
1 of 4
P/N XP3DNR092009• REV 01.00 • ISS 03SEP09
6
EN: Installation Sheet
2 of 4 P/N XP3DNR092009 • REV 01.00 • ISS 03SEP09
Description
The UVD-XP3DNR(-P) camera consists of the following parts:
• The camera assembly (Figure 1)
Table 1: Description of camera parts
1. Lens body
2. Bubble
3. Video monitor output
4. OSD control pad
5. Camera body
• Monitor output cable (Figure 2)
1. Monitor output BNC; 2. Monitor output RCA
• Mounting screws, wall anchors, and hex key
Use the video output BNC and power jack for normal
system operation. Use the monitor output cable for
installation and maintenance.
OSD control pad
The onscreen display (OSD) control pad (Figure 3: 1. OSD
control pad) is a five-direction joystick that provides the
ability to manually control the camera functions. Table 1
lists the OSD control pad functions and describes their use.
Table 2: OSD control pad functions
Pad directions Description
Up Moves the cursor upward to select an item.
Left Moves the cursor left to select or adjust the
parameters of the selected item.
Right Moves the cursor to the right to select or
adjust the parameters of the selected item.
Down Moves the cursor downward to select an
item.
Pad directions Description
Enter Press the center of the control pad to
display the Setup menu. If the selected item
has its own menu, press the control pad to
enter a submenu. Press the control pad for
2 seconds to save all settings and exit the
Setup menu.
Installation
Complete all the necessary programming before you install
the camera. This section provides information on how to
install the camera and adjust camera angle and focus.
WARNING: To reduce the risk of fire or electronic shock, do
not expose the camera to rain or moisture and do not
remove the cover or back.
Cable connection
To make cable connections, do the following:
1. Connect a coaxial cable from the camera’s BNC
connector to a CCTV monitor or video recording device.
2. Connect a 12 VDC or 24 VAC power supply to the
power input. The label on the camera gives the
following information:
Red cable. Power in.
Black cable. Power in.
White cable. Video out.
Black cable. Video ground.
Note: For AC24V or DC12V, Black or Red may be used for ground.
Camera installation
To mount the camera, attach the camera to the mounting
surface using the appropriate fasteners
Angle adjustment
To adjust the horizontal angle of the platform up to 180
degrees, turn the platform (Figure 4, number 1).
To adjust the horizontal angle of the rotor up to 350
degrees, turn the rotor on the platform (Figure 4, number 3).
To adjust the vertical angle of the platform up to 90
degrees, turn the platform (Figure 4, number 3).
Loading...