GE Security TVC-BIR-MR User Manual

GE
Security
TruVision Bullet IR Camera
Pocket Guide
g
1065696A
Copyright Copyright © 2008 GE Security. All rights reserved.
Disclaimer The information in this document is subject to
Tradema rks and patents
Intended
Document num/rev: 1065696A (November 2008).
change without notice. GE Security (“GE”) assumes no responsibility for inaccuracies or omissions and specifically disclaims any liabilities, losses, or risks, personal or otherwise, incurred as a consequence, directly or indirectly, of the use or application of any of the contents of this document. For the latest documentation, contact your local supplier or visit us online at www.gesecurity.com.
This publication may contain examples of screen captures and reports used in daily operations. Exam­ples may include fictitious names of individuals and companies. Any similarity to names and addresses of actual businesses or persons is entirely coincidental.
GE and the GE monogram are registered trademarks of General Electric Company. TruVision Bullet IR Camera is a trademark of G E Security.
Other trade names used in this document may be trademarks or registered trademarks of the manu­facturers or vendors of the respective products.
Use this product only for the purpose it was designed
use
for; refer to the data sheet and user documentation. For the latest product information, contact your local supplier or visit us online at www.gesecurity.com.
TruVision Bullet IR Camera
iii
Pocket Guide
FCC
compliance
directives
Regulatory
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful inter­ference when the equipment is operated in a resi­dential environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment .
EU
2004/108/EC (EMC directive). Non-European manu-
facturers must designate an authorized representa­tive in the Community. Our authorized manufacturing representative is GE Security B.V., Kelvinstraat 7, 6003 DH Weert, Nederland.
2002/96/EC (WEEE directive). Products marked with this symbol cannot be disposed of as unsorted municipal waste in the European Union. For proper recycling, return this product to your local supplier upon the purchase of equivalent new equipment, or dispose of it at designated collection points. For more information, visit www.recyclethis.info.
iv
TruVision Bullet IR Camera
v
Pocket Guide
Introduction . . . . . . . . . . . . . . . . . . . . 1
Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Contacting us . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Contact information . . . . . . . . . . . 10
vi
TruVision Bullet IR Camera
1
Pocket Guide

Introduction

This is the GE TruVision Bullet IR Camera Pocket Guide for models TVC-BIR-MR and
TVC-BIR-HR. This pocket guide describes a standard installation.

Overview

The TruVision Bullet IR Camera consists of the following:
• Camera with power and video output cables
• Flying lead
1 shows the parts of the camera, and
Figure
2 show the lens, IR LEDs, and the light
figure sensor.
1
A B
2
A Sunshield B Power and video
cable
TruVision Bullet IR Camera
3
Pocket Guide
2
A
B
C
A LED IR lights (total
number of lights varies by model)
B Lens
C Light sensor

Installation

Note: When installing the TVC-BIR-MR or
TVC-BIR-HR, please use the optional bracket, TVC-BIR-WM, which is sold separately.
To install the camera, do the following.
1. Using the mount as a template, place it level against the mounting surface and mark the position of the mounting holes.
2. Following all local codes, drill and prepare the mounting holes.
3. Securely fasten the mount to the mounting surface with the appro­priate fasteners.
4. If needed, seal all mounting holes so that no moisture can leak into the mounting surface.
4
TruVision Bullet IR Camera
5
Pocket Guide
5. Screw the camera into the mounting bracket. Ensure that the camera is firmly attached to the bracket.
6. Connect a 75 ohm coaxial video cable to the video cable, and connect a 12 VDC power supply to the power cable.
7. Adjust the camera position and angle as required.

Specifications

Image sensor 1/3 in. color CCD sensor Total pixels NTSC: 811(H) x 508(V)
Effective pixels NTSC: 768(H) x 494(V)
Synchronizing system 2:1 internal Scanning system NTSC: 525 lines, 60 fields
Video output 1.0 Vp-p / 75 ohm composite Electronic shutter NTSC: 1/60 to 1/100,000 second
PAL: 795(H) x 596(V)
PAL: 752(H) x 582(V)
PAL: 625 lines, 50 fields
PAL: 1/50 to 1/100,000 second
6
Variable Focal Lens TVC-BIR-MR: 3.5 to 12 mm
IR cut On DC drive type On S/N ratio More than 48 dB (AGC off) Minimum illumination TVC-BIR-MR:
Weatherproof IP67 IR distance TVC-BIR-MR:
IR trigger 3.1 lux / 3.7 lux (IR on/off) Power supply 24 VAC/12 VDC
TVC-BIR-HR: 6 to 50 mm
0.07 lux color / F1.4
0.00 lux IR on
TVC-BIR-HR:
0.2 lux color / F1.6
0.00 lux IR on
82 ft. (25 m) (20 IR LEDs)
TVC-BIR-HR: 180 ft. (55 m) (40 IR LEDs)
TruVision Bullet IR Camera
7
Pocket Guide
Current TVC-BIR-MR:
Power consumption TVC-BIR-MR: 10 W maximum
Weight TVC-BIR-MR: 1.7 lb. (0.75 kg)
Dimension (W x H x diam.)
Operating temp. 14 to 122°F (-10 to 50°C) Storage temp. -4 to 158°F (-20 to 70°C)
280 mA (IR OFF) 900 mA (IR ON)
TVC-BIR-HR: 280 mA (IR OFF) 1300 mA (IR ON)
TVC-BIR-HR: 14.3 W maximum
TVC-BIR-HR: 2.1 lb. (0.93 kg) TVC-BIR-MR:
3 x 3.27 x 5.53 in.
(76 x 83 x 140.5 mm)
TVC-BIR-HR:
3.5 x 3.74 x 6.2 in. (88 x 95 x 156.5 mm)

Contacting us

For help installing, operating, maintaining, and troubleshooting this product, refer to this document and any other documentation
provided. If you still have questions, see
Contact information on page 10.
Note: Be ready at the equipment before calling.

Online resources

Here are some useful links on our website
www.gesecurity.com:
Online library. From the Customer Support menu, select the Resource Library
link. After you register and log on, you may search for the documentation you need. (For translated manuals, contact your local supplier.)
1. Many GE documents are provided in English only as PDFs. To read these documents, you will need Adobe Reader, which you can download free from Adobe’s website at www.adobe.com.
1
8
TruVision Bullet IR Camera
9
Pocket Guide
Training. To view any available online training for GE Security products, select the Training link. (Online training is not available for all products.)
Warranty and terms. From the Customer Support menu, select Return and Warranty
Policy Statement or Terms and Conditions Policy Statement.
Customer service and technical support. From the Customer Support
menu, select Customer Service or
Technical & Application. Select a product
category for the contact information or use the menu to select a location outside the US.

Contact information

North America
T: 888 GE Security. Toll-free in US, Puerto Rico, Canada.
503.885.5700 outside the toll-free area.
F: 888.329.0332 (Tualatin tech support)
561.998.6232 (Boca Raton tech support)
E: nstechsrv@ge.com
gesecurity.customerservice@ge.com
Latin America
T: 305.593.4301F:305.593.4300 E: InfraSec.TechnicalServicesLatinAmerica@ge.com
InfraSecCustomerService.LatinAmerica@ge.com
Europe, Middle East, and Africa
W: At www.gesecurity.eu, select Customer Support.
China, India, Singapore, Taiwan, Southeast Asia
E: ges.asiatechservice@ge.com
Australia, New Zealand
E: techsupport@gesecurity.com.au
10
Loading...