Gerber D462038BN, D462038 Installation Manual

Multi-Function Handshower
Ducha de mano con multifunción
Douche à main multifonction
Adjustable
Llave ajustable
Clé à molette
1. Remove the existing showerhead from the showerarm. Clean the debris from
2. Wrap the threads of the showerarm with the plumber's tape (included) (Fig 2).
3. Screw the showerarm mount onto the showerarm supply pipe threads (Fig 3).
4. Connect the shower hose to bottom outlet of the showerarm mount and handshower
5. Place the handshower with conical attached into the showerarm mount holder (Fig 5).
Wrench
the inside of the showerarm and the showerarm threads. Run water to flush the residual debris from the inside arm (Fig 1).
(Fig 4).
Needle-nose Pliers
Alicates de extremos finos
Pince à bec effilé
Shown/Mostrado/Illustré
1.
Remove the showerhead from the hose by unscrewing the hose conical counter-clockwise (Fig 1).
2.
The flow controller/check valve is located at the opening of the handshower handle and has a different color plastic housing than the handshower conical threads (Fig 2). Use the needle-nosepliers to grasp the flow controller/check valYe and pull the flow controller/check valve out. Take care not to use excessive force when grasping perimeter edge of the flow controller/check valve so as to avoid damage (Fig 2 & 3).
3. Remove any debris from the flow controller/check valve. Reinstall the flow controller/check valve by pressing into opening of the handshower handle. Then reattach the hose conical to the handshower threads.
Loading...
+ 1 hidden pages