Gerber D462032BN, D462035BN, D462035, D462033, D462032 Installation Manual

Five Function Handshower

Ducha de mano con 5 funciones

Douche à main de 5 fonctions

Adjustable

Llave ajustable

Clé à molette

1. Remove the existing showerhead from the showerarm. Clean the debris from the
inside showerarm and the showerarm threads. Run water to flush the residual
debris from the inside arm (Fig 1).

2. Wrap the threads of the showerarm with plumber’s tape (included) (Fig 2).

3. Screw the showerarm mount onto the showerarm supply pipe threads (Fig 3).

4. Connect the shower hose to the bottom outlet of the showerarm mount and
handshower (Fig 4).

5. Place the handshower with conical attached into the showerarm mount holder (Fig 5).

Wrench

Needle-nose Pliers

D462032/D462033/D462034/D462035

Alicates de extremos finos

Pince à bec effilé

Shown/Mostrado/Illustré

1. Remove the handshower from the hose by unscrewing the hose conical
counter-clockwise (Fig 1).

2. The flow controller/ check valve is located at the opening of the handshower
handle and has a different color plastic housing than the handshower
conical threads (Fig 2). Use the needle-nose pliers to grasp the flow
controller/ check valve and pull the flow controller/ check valve out. Take
care not to use excessive force when grasping the perimeter edge of the
flow controller/ check valve so as to avoid damage (Fig 2 & Fig 3).

3.Remove any debris from the flow controller/ check valve. Reinstall the
flow controller/ check valve by pressing into the opening of the handshower
handle. Then reattach the hose conical to the handshower threads.