Gerber D462025BR, D462025BN, D462025 Installation Manual

Multi-Function Handshower

Ducha de mano con multifunción

Douche à main multifonction

Adjustable

Llave ajustable

Clé à molette

1. Remove the existing showerhead from the showerarm. Clean the debris from

2. Wrap the threads of the showerarm with the plumber's tape (included) (Fig 2).

3. Screw the showerarm mount onto the showerarm supply pipe threads (Fig 3).

4. Connect the shower hose to bottom outlet of the showerarm mount and handshower

5. Place the handshower with conical attached into the showerarm mount holder (Fig 5).

Wrench

the inside of the showerarm and the showerarm threads. Run water to flush
the residual debris from the inside arm (Fig 1).

(Fig 4).

Needle-nose Pliers

Alicates de extremos finos

Pince à bec effilé

D462030

Shown/Mostrado/Illustré

D462025

D462036/D462047
D462046/D461046

1.

Remove the showerhead from the hose by unscrewing the hose
conical counter-clockwise (Fig 1).

2.

The flow controller/check valve is located at the opening of the
handshower handle and has a different color plastic housing than
the handshower conical threads (Fig 2). Use the needle-nose pliers
to grasp the flow controller/check valve and pull the flow
controller/check valve out. Take care not to use excessive force
when grasping perimeter edge of the flow controller/check valve
so as to avoid damage (Fig 2 & 3).

3. Remove any debris from the flow controller/check valve. Reinstall
the flow controller/check valve by pressing into opening of the
handshower handle. Then reattach the hose conical to the handshower
threads.