Gerber D461024, D461024BS, D461024BR, D461024BN Installation Manual

Surge

Showerarm Mount Assembly

Assemblage de fixation de bras de douche

Ensamblaje de montaje del brazo de ducha

Adjustable

Llave ajustable

Clé à molette

Wrench

Needle-nose Pliers

Alicates de extremos finos

Pince à bec effilé

Plumber’s Tape

Cinta de plomero

Ruban pour tuyau

• Installation Steps:

1. Remove existing showerhead from showerarm. Clean debris from inside showerarm and showerarm threads. Run water to flush residual debris from inside arm (Fig 1).

2. Wrap threads of showerarm with plumber's tape (included) (Fig 2).

3. Screw showerarm mount onto showerarm supply pipe threads (Fig 3).

4. Connect shower hose to bottom outlet of showerarm mount and handshower (Fig 4).

5. Place handshower with conical attached into showerarm mount holder (Fig 5).

• Etapas para la instalación:

1. Quite la cabeza de la ducha del brazo de la ducha. Limpie la suciedad en el interior del brazo y en la rosca del brazo. Deje correr al agua para que se lleve los restos de suciedad del interior del brazo (fig. 1).

2. Envuelva la rosca del brazo de la ducha con cinta de plomero (incluida) (fig. 2).

3. Enrosque el soporte del brazo de la ducha en las roscas del tubo de alimentación del brazo de la ducha (fig. 3).

4. Conecte la manguera de la ducha a la salida inferior del soporte del brazo de la ducha y a la ducha de mano (fig. 4).

5. Ponga la ducha de mano por su sección cónica en la sujeción del soporte del brazo de la ducha (fig. 5).

D461023 D461024

Shown/Mostrado/Illustré

Fig 1

Fig 4

Fig 5

Remove the handshower from the hose by unscrewing the hose conical counter-clockwise (Fig 1).

The flow controller/check valve is located at the opening of the handshower handle and has a different color plastic housing than the handshower conical threads (Fig 2). Use the needle-nose pliers to grasp the flow controller/check valve and pull the flow controller/check valve out. Take care not to use excessive force when grasping perimeter edge of the flow controller/check valve so as to avoid damage (Fig 2 & 3).

3. Remove any debris from the flow controller/check valve. Reinstall the flow controller/check valve by pressing into opening of the handshower handle. Then reattach the hose conical to the handshower threads.

+ 1 hidden pages