Page 1
Caution : You must read this before you proceed
Ottoman
1 OF 6
Page 2
Label Picture Description QTY
A Ottoman 1
B Wooden Leg 4
Label Picture Description QTY
① Bolt (M8X50mm)
9
② Washer
9
③ Spring Washer
9
④ Allen Key
1
Before
Beginning
Assembly:
2 OF 6
Page 3
This Ottoman has multiple parts and may require up to 30 minutes to assemble.
To give you an overview of the Ottoman parts, the above picture is to help you
put the various parts into perspective. Please read through the instructions
below to familiarise yourself with the parts and steps before assembly.
Place the Ottoman(A) facedown on a clean, non-marring surface, as shown in
picture above.
Carefully open the Dust Cover at the bottom, and remove the Wooden Legs(B)
and Hardware.
Overview
Step 1
Wooden Leg(B)
Ottoman (A)
FRONT FACING
Wooden Leg(B)
3 OF 6
Page 4
Stand the Ottoman up.
Place the Ottoman on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected.
Gently and carefully, sit on the Ottoman.
This will help to align all parts at all joints.
Then get off the Ottoman, and carefully place the Ottoman facedown.
Then proceed to tighten all Bolts at all joints in a sequential
manner.
If there are still wobbles, loosen the Bolts and execute the same
process.
Step 3
Step 2
Insert one Wooden Leg(B) into the mounting position of the Ottoman(A).
Attach using Bolts(①), Spring Washers(③) and Washers(②) with Allen Key(④).
Do not fully tighten the Bolts.
Repeat the same process to attach the remaining three Wooden Legs(B).
Wooden Leg(B)
Ottoman(A)
4 OF 6
Page 5
Step 4
Smooth down with your hand on the fabric and stick on the magic
Tape on all 4 sides at the edge of the Ottoman.
Step 5
Stand the Ottoman up.
Your Ottoman is ready for use.
This Ottoman can only be used on a flat, level surface.
5 OF 6
Page 6
6 OF 6
Loading...