Page 1
Label Picture Description QTY
A Table Top 1
B Framework 1
C Table Leg 3
D Tempered Glass 1
Assembly Instructions
Caution: You must read this before you proceed
Table
Picture
Part List
Page 1 OF 5
Page 2
Label Picture Description QTY
①
Bolt
(M6X20mm)
7
② Cap 7
③ Allen Key 1
④ Washer 7
Hardware
Assembly Preparation
Before
Beginning
Assembly:
×7
×7
×7
Page 2 OF 5
Page 3
Assembly Steps
Overview
This Table has multiple parts and may require up to 30 minutes to assemble. To give you an overview
of the the Table parts, the above picture is to help you put the various parts into perspective. Please
read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1
Unpack and place all parts on a clean, non-marring surface.
Step 2
Place the Table Top(A) facedown onto a clean, non-marring surface.
Align the Table Legs(C) to Table Top(A) as shown above.
Attach Table Legs(C) to Table Top(A) using Bolts(①) and Washers(④) with Allen Key(③).
Do not fully tighten the Bolts.
Step 3
Align the Framework(B) to Table Legs(C) as shown above.
Attach Framework(B) to Table Legs(C) using Bolts(①) and Washers(④) with Allen Key(③).
Do not fully tighten the Bolts.
FRONT FACING
Table Top (A)
Table Leg (C)
Framework (B)
Page 3 OF 5
Page 4
Step 6
Stand the Table up.
Carefully place the Tempered Glass(D) on the Table.
Step 4
Stand the Table up.
Exert pressure floorwards, onto the Table with both your hands.
This pressure will help the Legs and Table Top reach full alignment status.
Check for wobbles on a LEVEL surface.
If no wobbles are found proceed to tighten the Bolts in a sequential manner, until evenly secured.
When tightening the Bolts tighten sequentially.
Do not tighten any Bolt fully and then move on towards the next one.
If there are still wobbles, loosen the Bolts and excute the same above process.
Step 5
Turn over the Table.
Cover the Bolts(①) using Caps(③).
Page 4 OF 5
Page 5
Step 7
Your Table is ready for use.
This Table can only be used on a flat and level surface.
age 5 OF 5
Loading...