Page 1
Caution : You must read this before you proceed
Chair
CAUTION: This Chair is NOT a TOY
Keep your child / children at bay in the process of assembly.
For turning the Chair and to prevent damage to the Chair, 02
persons may be needed to execute this action.
Whenever moving / lifting the Chair and to prevent damgge to the Chair two
adults are needed to execute these action.
1
Page 2
Label Picture Description QTY
A Backrest Panel 1
B Upper Leg Panel 1
C Lower Leg Panel 1
D Seat Cushion 1
E Back Cushion 1
Label Picture Description QTY
①
Bolt (M6x60mm) 5
②
Screw (M4x30mm) 5
③
Allen Key 2
④
Screw Driver (not
provided)
1
Before Beginning Assembly:
2
Page 3
Overview
This chair has multiple parts and may require up to 30 minutes to assemble.
To give you an overview of the chair parts, the above picture is to help you
put the various parts into perspective. Please read through the instructions
below to familiarise yourself with the parts and steps before assembly.
Unpack and place all parts on a clean, non-marring surface.
Step 1
Backrest Panel (A)
Upper Leg Panel (B)
Lower Leg Panel (C)
Back Cushion (D)
Seat Cushion (E)
FRONT FACING
3
Page 4
Step 2
Place the Backrest Panel (A) facedown on a clean, non-marring surface.
Attach Upper Leg Panel (B) to Backrest Panel (A) using Bolts (①) with Allen
key (③) as shown above.
Do not fully tighten the Bolts.
Caution: At the same time, please don't place your hands between the
gaps to avoid injury.
4
Page 5
Insert Lower Leg Panel (C) to the pre-assembled in step 2 as pictured above.
Attach Lower Leg Panel (C) to Backrest Panel (A) using Bolts (①) with Allen
key (③).
Do not fully tighten the Bolts.
Attach Upper Leg Panel (B) and Lower Leg Panel (C) to Backrest Panel (A)
using Screws (②) with Allen key (③) as shown above.
Do not fully tighten the Screws.
Step 4
Step 3
A
B
A
C
C
B
5
Page 6
Place the Chair on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected.
Gently and gracefully, sit into to the Chair.
This will help to align all the parts at all joint areas.
Then get off the Chair and proceed to tighten the Bolts and Screws in a
sequential manner.
When tightening the Bolts and Screws tighten sequentially.
DO NOT tighten any Bolt or Screw fully and then move on towards the
next one.
If there are still wobbles, loosen the Bolts and Screws and execute this same
process.
Place the Seat Cushion (D) and Back Cushion (E) into the Chair.
Attach the velcro of Seat Cushion (D) to the Chair as shown above.
Step 5
Step 6
Your Chair is ready for use.
This Chair can only be used on a flat , level surface.
6
Page 7
7
Loading...