Page 1
Assembly Instructions
Caution: You should read this carefully before you proceed
Arm Chair
CAUTION: This Chair is NOT a TOY.
Keep your child / children at bay during the assembly process.
Whenever lifting or moving the Chair and to prevent any damage to
the it, two adults may be needed to execute these actions.
Please look in the Seat Panel for hardware packs.
1
Page 2
Label Picture Description QTY
A Backrest Panel 1
B Left Leg Panel 1
C Right Leg Panel 1
D Support Bar 1
E Seat Panel 1
F Seat Cushion 1
G Back Cushion 1
Label Picture Description QTY
①
Bolt
(M6x30mm)
5
②
Bolt
(M6x45mm)
5
③
Screws
(M6x35mm)
5
④
Sleeve Nut
(M6x15mm)
5
⑤
Allen Key 2
Hardware
Part List
2
Page 3
Overview
Before Beginning Assembly:
Assembly Steps
Assembly Preparation
This Chair has multiple parts and may require up to 30 minutes to assemble. To
give you an overview of the Chair parts, the above picture is provided to help
you put the various parts into perspective. Please read through the instructions
below to familiarise yourself with the parts and steps before assembly.
FRONT FACING
Seat Cushion (F)
Backrest Panel (A)
Right Leg Panel (C)
Seat Panel (E)
Back Cushion (G)
Left Leg Panel (B)
Support Bar (D)
3
Page 4
Place the Backrest Panel (A) upright as shown in the picture above onto a
clean, soft surface to avoid any scratches or damages to the product.
With assistance from your adult partner(s), attach the Left Leg Panel (B) to the
Backrest Panel (A) using Bolts(①), Sleeve Nuts(④) and the Allen Key(⑤) as
shown above.
Do not fully tighten the Bolts at this time.
Unpack and place all parts on a clean, non-marring surface.
Step 1
Step 2
Step 3
Attach the Right Leg Panel (C) to the pre-assembled in step 2 by using
Bolts(①), Sleeve Nuts(④) and the Allen Key(⑤) as shown above.
Do not fully tighten the Bolts at this time.
4
Page 5
Attach the Support Bar (D) to the assembled frame in step 3 by using Bolts(②)
and the Allen Key(⑤) as shown above.
Do not fully tighten the Bolts at this time.
Step 4
Step 5
Attach the Seat Panel (E) into the Chair as shown in picture above.
Affix the Seat Panel (E) to the Chair using Screws(ˆ③) and the Allen Key(⑤).
Note: Insert the Screws(ˆ③) from the inside to the outside of the Seat Panel (E)
DO NOT FULLY TIGHTEN THE SCREWS.
Turn the Chair right side up.
Inspect the Chair and make sure all parts are adequately connected.
Carefully sit onto the Chair. This pressure will help align all parts at all
joints.
In a sequential manner, tighten all Bolts and Screws at all joints.
5
Page 6
Step 6
Place the Seat Cushion (F) and the Back Cushion (G) into the Chair, and affix
the velcro straps around the Chair as shown above.
Your Chair is ready to be used.
This Chair can only be used on a flat, level surface.
6
Loading...