Page 1
Caution: You must read this before you proceed
BARCART
CAUTION : This Barcart is NOT a TOY.
Keep your child / children at bay during the assembly process.
For moving the Barcart and to prevent damage to the Barcart, two adults are
needed to execute this action.
Page 2
Label Picture Description QTY
D Handle 2
A Leg Frame 2
B Upper Tray 1
C Lower Tray 1
E Blocked Wheel 2
F Wheel 2
Hardware
Label Picture Description QTY
Bolt
(M6 x 40mm)
5
Page 3
Before Beginning Assembly:
Screw
5
(M6 x 50mm)
Allen Key 1
Spanner Wrench 2
Page 4
Tray
Stretcher
Tray
Leg Frame
OVERVIEW
Upper
Wheel
Blocked Wheel
Lower
This Barcart has multiple parts and may require up to some 30 minutes
to assemble. To give you an overview of the Barcart, the above picture
is to help you put the various parts into perspective. Please read through
the instructions here below to familiarise the parts and steps before
assembly.
Step 1
Unpack and place all parts on a clean, non-marring surface.
Step 2
Page 5
Place the Upper Tray (B) on a clean, non-marring surface as shown in
pricture above.
Position Leg Frame (A) into Upper Tray (B), secure by using Bolts( )
with Allen Key( ).
Do not fully tighten the Bolts.
Step 3
Insert Stretch (D) into Leg Frame (A) as shown in the picture.
Repeat the same process with
other stretch (D).
Page 6
Step 4
Secure Leg Frame (A) into Upper Tray (B) by using Bolts( ) with Allen
Attach the other Leg Frame (A) into Handles (D) and Upper Tray (B) as
shown in the picture.
Key( ).
Do not fully tighten the Bolts
Step 5
Page 7
With assistance from your adult partners, position the Lower Tray (C)
onto the Leg Frame (A) as shown in picture above.
Secure the Lower Tray (C) and Leg Frame (A) using Screws( ) with
Allen Key ( ).
Do not fully tighten theScrews
Step 6
Insert Blocked Wheel (E) and Wheel (F) into Leg Frame (A) as shown
in the picture. Use Spanner Wrench ( ) to secure the wheels into the
Leg Frame (A).
Repeat the same process with other wheels
Note: On this step,it will have two Blocked Wheels and two Wheels. Two
Blocked Wheels should be in one side that parallel with Handle (D)
Step 7
Page 8
With assistance from your adult partners, turn the Barcart back to normal flat ground
EXERT pressure, floorwards, onto the Barcart.
This pressure will help the Legs and Barcart Top reach alignment at all joints.
Check for wobbles.
In a sequential manner, gradually tighten all Screws, Bolts until evenly secured.
Inspect the Barcart and make sure all parts are adequately connected.
Your Barcart is ready for use.
This Barcart can only be used on a flat, level surface.
Page 9
Do not put hot items directly on furniture surface
Do not clean furniture with harsh cleansers or polish.
Do not place furniture under direct sunlight.
Do not place furniture near heating or cooling vents.
Do not write on furniture without a padded barrier to protect the surface.
Do not place furniture outside . For indoor use only .
Not for commercial use. For residential use only .
Stains may be removed with mild soap solution and damp cloth.
Children should not climb or jump on the furniture.
Dust and pick-up spills using a clean, non-colored, lint-free cloth .
Loading...