Assembly Instructions
Caution: You must read this before you proceed
TABLE
Caution: This Table is NOT a TOY
Keep your child/ children at bay during the assembly process.
Whenever moving/lifting the Table and to prevent damage to the Table,
two adults are needed to execute these actions.
Page 1 of 9
①
②
③
④
⑤
Parts List
Label Picture Description QTY
A Table Top 1
B Legs 4
C
D
First Leg
1
Support Bar
Second Leg
1
Support Bar
Hardware
Label Picture Description QTY
Bolt
(M8x50mm)
Screw
(M6x45mm)
Screw
(M6x90mm)
9
2
5
Washer
Allen Key
9
1
Page 2 of 9
Assembly Preparation
Before Beginning Assembly:
Noble House Home Furnishings LLC
Page 3 of 9
Assembly Steps
Overview
First Leg
Support Bar (C)
Table Top (A)
Leg (B)
Second Leg
Support Bar (D)
FRONT FACING
This Table has multiple parts and may require up to 30 minutes to assemble. To give
you an overview of the Table parts, the above picture is to help you put the various
parts into perspective. Please read through the instructions below to familiarise
yourself with the parts and steps before assembly.
Step 1
Unpack and place all parts on a clean, non-marring surface.
Page 4 of 9
Step 2
D
C
B
4
1
5
Attach Leg (B) to the Table Top (A) using Bolts(①), and Washers(④) with Allen
Key(⑤).
Do not fully tighten the Bolts.
Repeat the same process with the remaining three Legs (B).
Step 3
A
5
2
Place First Leg Support Bar(C) to Second Leg Support Bar (D), as shown above.
Attach First Leg Support Bar(C) to Second Leg Support Bar (D) using Screws(②)
with Allen Key(⑤).
Do not fully tighten Screws.
Page 5 of 9
Step 4
A
B
D
C
3
5
Attach the finished part in step 3 to the Legs (B), as shown above.
You may need to apply a little pressure to the Legs-pushing outwards to enable
place tenons from the finished part in step 3 into mortises on the Legs (B).
Secure the finished part in step 3 to the Legs (B) using Screws(③) and Allen
Key(⑤).
Do not fully tighten Screws.
Page 6 of 9
If the Table is not Stable it could lead to damage to the product.
Step 5
Adjust Pre-installed Levellers height for
Stand the Table up, with assistance from your adult partner.
Exert pressure floorwards, onto the Table with both your hands.
This pressure will help the Legs and Table Top reach full alignment status.
Check for wobbles on a LEVEL surface.
If no wobbles are found proceed to tighten the Bolts and Screws in a sequential
manner, until evenly secured.
When tightening the Bolts and Screws tighten sequentially.
Do not tighten any Bolt or Screw fully and then move on towards the next one.
With assistance from your adult partners, adjust the Levellers to desired height
to avoid wobbles.
If there are still wobbles, loosen the Bolts and Screws and excute the same
above process.
Page 7 of 9
Step 5
Your Table is ready for use.
This Table can only be used on a flat, level surface.
Page 8 of 9
Page 9 of 9
Loading...