Page 1
Caution : You must read this before you proceed
Club Chair
Page 1 OF 7
Page 2
Label Picture Description QTY
A
Backrest (with the
pre-installed Rail)
1
B
Chair Seat (with the
pre-installed Rail)
1
C Front Leg 2
D Back Left Leg 1
E Back Right Leg 1
Label Picture Description QTY
①
Bolt (M8*50MM) 5
②
Spring Washer Rings 5
③
Flat Washer Rings 5
④
Allen Key 1
Page 2 OF 7
Page 3
This Club Chair has multiple parts and may require up to some 30
minutes to assemble. To give you an overview of the Club Chair
parts, the above picture is to help you put the various parts into
perspective. Please read through the instructions below to
familiarise yourself with the parts and steps before assembly.
Before
Beginning
Assembly:
Backrest(A)
Front legs(C)
Chair Seat(B)
FRONT FACING
Back right leg(E)
Page 3 OF 7
Page 4
Step 1
Step 2
Insert Back Right Leg (E) into the mounting position of Seat(B)
and attach using Bolt(①), Spring Washer(②) and Washer(③)
with Allen Key(④).
Do not fully tighten the Bolts.
Repeat the same process to attach the remaining three Legs.
Be sure to place the correct Legs in the correct postions as
pictured above.
Place the Seat(B) on a clean, non-marring surface with the
bottom facing you, as shown in picture above.
Carefully unzip the dust cover at the bottom, and remove the
Legs and Hardware.
②
③
①
B
B
E
C
D
Page 4 OF 7
Page 5
Step 3
Step 4
Stand the Chair up.
With assistance from your partner, lift the Backrest(A) up.
Align the Rails on Backrest with the Rails on Seat.
Then push the Backrest(A) downwards until it is fully slotted and
locked into position.
Both sides of Backrest(A) must be slipped and slid into position at
the SAME TIME until it fully locks in its housing.
Note: Ensure the Rail on Backrest locks into the Rail on
Armrest.
Assistance from your adult partner is needed during this
process.
Zip up the dust cover at the bottom of the Seat.
A
B
C
Rail on
Backrest
Rail on
Armrest
Page 5 OF 7
Page 6
Step 5
Step 6
Stand the Club Chair up.
Your Club Chair is ready for use.
This Club Chair can only be used on a flat, level surface.
Stand the Club Chair up.
Place the Club Chair on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected.
Gently and carefully, sit on the Club Chair.
This will help to align all parts at all joints.
Then get off the Club Chair, and carefully place the Club Chair
facedown.
Then proceed to tighten all Bolts at all joints in a sequential
manner.
If there are still wobbles, loosen the Bolts and execute the same
process.
Page 6 OF 7
Page 7
Page 7 OF 7
Loading...