Page 1
Caution : You must read this before you proceed
Barstool
Label Picture Description QTY
A Seat 1
B Leg Frame 1
Page 1 OF 6
Page 2
Label Picture Description QTY
①
Nut 5
②
Spanner 1
③
Washer 5
④
Spring Washer 5
Before
Beginnin
g
Assembl
y:
Page 2 OF 6
Page 3
Overview
This Barstool has multiple parts and may require up to some 20 minutes to
assemble. To give you an overview of the Barstool parts, the above picture is to
help you put the various parts into perspective. Please read through the
instructions below to familiarise yourself with the parts and steps before
assembly.
Step 1
Open the carton and place all the parts on a clean, non-marring surface.
A
B
FRONT FACING
Seat (A)
Leg Frame (B)
Page 3 OF 6
Page 4
Step 2
Place the Seat(A) facedown, then align the Leg Frame(B).
Attach the Leg Frame(B) to Seat(A) using Nuts(①), Spring Washers(④) and
Washers(③) with Spanner(②).
Do not fully tighten the Nuts.
Step 3
B
①
②
③
④
B
Page 4 OF 6
Page 5
Place the Barstool on a LEVEL SURFACE to see if it wobbles.
If it wobbles, lift the Barstool some 30cm to 50cm high from the ground.
Keep your feet and toes well away from the drop zone.
Drop the Barstool freely and vertically with the four legs, hitting the ground, at
the same time.
This Drop Test will help to ensure that all the Nuts and gaps to reach full
alignment status.
Test again for evenness on a LEVEL SURFACE.
If no wobbles are found, lay down the Barstool and proceed to tighten all the
Nuts.
When tightening the Nuts, tighten sequentially.
DO NOT tighten any Nut fully and then move on towards the next one.
This could cause the frame to warp.
If there is still wobbles, loosen the Nuts and execute this same drop test.
If the Barstool is not stable, it could lead to damage to the product.
Step 4
Your Barstool is ready for use.
This Barstool can only be used on a flat, level surface.
Page 5 OF 6
Page 6
Page 6 OF 6
Loading...