Page 1
PENDANT LIGHT
TOOLS AND MATERIALS REQUIRED:
Wiring supplies
Phillips
Screwdriver
Pliers Wrench
Wire Cutters
SAFETY PRECAUTIONS:
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE
BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND
WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL BOX.
NOTE: Product May Not Look Exactly As Shown In Figures.
INSTALLATION:
as required by
the Canadian
Electrical Code
and/or the
Electrical code
Quebec
Studs
Electrical
Box
Electrical Box Screws
(not included)
Canopy
Mounting
Bracket
1. Loosen “B”. Adjust stud to
“B”
desired length and lock in place
with “B”.
2. Mount the mounting
bracket to electrical box using
electrical box screws (not
included). Make sure the studs
on the mounting bracket are
facing out from the electrical
box.
3. Adjusting the length of
flexible cord. For safety, do
not release the knot inside
canopy.
Star
Washer
Fixture
Stud
Cap
Nut
5. Once wire connections are
completed, carefully tuck wires
and wire nuts into the
electrical box making sure no
bare wire (on the black and
white) is visible at the wire
nuts.
6. Install the light fixture to
the ceiling by aligning the
hole(s) in the fixture with the
studs on the mounting bracket.
Secure fixture in place with star
washer(s) and cap nut(s).
7. Install specified bulb type
and wattage (not included).
House supply
Ground wire
Fixture
Ground wire
Bare Copper
Ground Wire
Black
White
4. Connect the ground wires
(bare copper or green) from
your fixture to the ground wire
(bare copper or green) or
ground screw in the electrical
box. Attach the black wire (or
wire marked “SPT-1”) from the
light fixture to the black wire in
the electrical box. Attach the
white wire from the light fixture
to the white wire in the
electrical box.
Bulb
Loading...