George Oliver LGLY3789 Installation & Assembly

Assembly Instructions

Caution : You must read this before you proceed

BAR TABLE

Part List

Label Picture Description QTY

A Table Top 1

B Table Leg B 2

C Table Leg C 2

D Side Stretcher 2

E Cross Bar 1

Page 1 of 6

Hardware

Label Picture Description QTY

JCBB M8 x 70mm

①

② Allen Key M5 1

③

④ Allen Key M4 1

⑤ FH SCREW #8 x 32mm 4

+ S/W 5/16"
+ F/W 5/16" x 22mm

JCBC M6 x 45mm
+ S/W M6
+ F/W M6 x 13mm

8

2

Assembly Preparation

Before
Beginning
Assembly:

Page 2 of 6

Assembly Steps

Overview

Table Leg(C)

Table Leg(B)

CrossBar(E)

Table Top

Table Leg(B)

Table Leg(C)

Side
Stretcher(D)

This Bar Table has multiple parts and may require up to some 30 minutes to
assemble. To give you an overview of the Bar Table parts, the above picture
is to help you put the various parts into perspective. Please read through the
instructions below to familiarise yourself with the parts and steps before
assembly.

Step 1

TableLeg(B)
hasasmall
holefor
identification

Place the Table top (A) on a soft surface to avoid any scratches or damages
to the product and place the Table Leg (B) onto the of table top corner block
with your adult partner. Table Leg (B) has a small hole identification.

Fix the Table Leg (B) with JCBB Bolt ① + Spring Washer + Flat Washer
using Allen Key ②.

Repeat the step for Table Leg (C) as shown.
DO NOT FULLY TIGHTEN THE BOLT.

Page 3 of 6

Step 2

Place the Cross Bar (E) with Side Strecther (D) as shown.
Then, fix the Cross Bar (E) with JCBC Bolt ③ using Allen Key ④.

DO NOT FULLY TIGHTEN SCREWS.

Step 3

Place the Assembled part that finished on step 2 onto the mounting position
of the Table Leg.
Then, slot in the another Table Leg (B) and (C) on the Side stretcher
mounting position.

Page 4 of 6

Step 4

Repeat step 1, Fix the Table Leg (B) and (C) with JCBB Bolt ① + Spring
Washer + Flat Washer using Allen Key ②.
Fix the Side Stretcher (C) with CSK Screw ⑤ using Screwdriver (not

provided).

In case the table wobbles, need loosen tighten the screw and bolts, and use
your hand press the top of the table, to make sure the table eveness, and
then full tighten the bolts sequence.

FULLY TIGHTEN THE BOLT.

With assistance from your adult partner, stand the Table up.
Your Table is now ready for use.

Page 5 of 6

Care & Maintenance

Page 6 of 6