Page 1
ASSEMBLY INSTRUCTIONS
CHAIR
ASSEMBLY
REQUIREM
ENTS:
1-Person
Assembly
20 Minutes
Assembly Time
Per Chair
(Approximate)
Thank you for purchasing our product!
Please refer and use this assembly instruction to assemble the product.
Contact our customer service department in case there are any missing or
damage parts or hardware. Replacement parts are normally shipped
within 2 or 3 days.
We appreciate your business!
ASSEMBLY PREPARATION
1. Remove all packaging materials, staples and packing straps from the carton.
2. Refer to Parts List and Hardware List and ensure they are complete before you start assembling.
3. Place all wooden parts on a clean, flat and soft surface (e.g. carpet or rug) to prevent parts from getting
scratched.
SAFETY PRECAUTION:
1. KEEP ALL HARDWARE PARTS OUT OF REACH OF CHILDREN.
2. DISPOSE PLASTIC PACKAGING MATERIAL IMMEDIATELY TO AVOID ANY RISK OF SUFFOCATION TO CHILDREN AND
ANIMALS.
TIPS FOR ASSEMBLY:
1. Allow ample room for assembly and in close proximity to where product will be placed.
2. Assemble the product on a surface that does not scratch or damage the exterior gloss and finish of the furniture.
3. Please check all of the parts and quantities are included before assembly. Contact customer service for missing
parts.
4. Identify all of the parts, hardware and quantities required for each step.
5. During assembly, do not over-tighten any fittings as this may cause damage.
6. DO NOT USE POWER TOOLS TO ASSEMBLE THIS PRODUCT.
7. Always place the product on a flat surface.
8. Do not sit or stand on the partially assembled product; only use the product for which it is intended.
CARE AND MAINTENANCE
• Use a slightly damp cloth to clean the product. Do not use bleach or abrasive cleaning material.
• Check all the fittings periodically and re-tighten as necessary. Do not use the product if any of the parts is
damaged or broken.
• Never allow any kind of liquid to remain on your furniture. Absorption
can cause wood to warp or delaminate.
• Do not place hot items (e.g. hot drinks) directly onto the wood surface.
• Do not drag and/or pull the furniture.
This product is for indoor and household use only - not for commercial use.
Page 1 of 2
Page 2
ASSEMBLY INSTRUCTIONS
CHAIR
PARTS & HARDWARE LIST
Ax1
Ex4
Spring Washer
Remove
Plastic
Case (H)
H
Seat
Bx1
Fx4
Leg
Spacer
Cx4
Gx1
Screw
Allen Key
C
E
D
Dx4
Flat Washer
Hx4
Plastic Case
G
Bracket
a) Place Seat (A) on an elevated
surface (e.g. table top) with
bottom-side faced up as shown.
b) Remove Plastics Case (H) to
expose bracket.
c) To fasten Leg to Seat, place
Spacer (F) on Screw Mount.
Next, position leg bracket over
(F) and insert Screw (C) fitted
with Spring Washer (E) and Flat
Washer (D). Use Allen Key (G)
to drive (C). Do not tighten (C)
completely until all 4 screws are
in place.
The assembly of the chair is
complete. Place the chair
upright.
F
B
Screw
Mount
A
Page 2 of 2
Loading...