Quick Reference Guide
January 2017
Genie Z-80/60
Rev A
Turn to platform position.
Steer Mode
Drive Enable
has been interrupted. To drive, move the drive
direction arrows on the platform box and drive
Engine idle select
Turtle symbol light on indicates low idle
Platform Overload
Drive Select
Operating Envelope Indicator Lights
work in the direction that will level the platform. Level the platform until
Z-80/60
Quick Refer enc e Gui d e
January 2017
Genie Z-80/60 Rev A
Z-80/60 from SN 5306
This Quick Reference Guide is intended for operators who are properly trained to safely operate the machine.
Getting Started:
Step 1: Read the Operators Manual and Perform the pre-operation inspections and tests.
Step 2
Step 3
Step 4
Pull out Red Emergency Stop buttons. Start Engine.
Controls and Indicators:
The Z-80/60 machines will have one of these two styles of graphics on the platform control panel.
The indicator light next to the current steer mode will be on.
or
Light on indicates that the boom has moved
past a circle-end tire and the drive function
enable switch and slowly move the drive
control handle off center. Use the color-coded
chassis to identify the direction the machine
will travel.
Rabbit and foot switch symbol light on
indicates foot switch activated high idle
is selected.
Rabbit symbol light on indicates high
idle is selected.
is selected.
Light flashing indicates the platform is
overloaded. The engine will stop and no
functions will operate. Remove weight from
the platform until the light goes off and then
restart the engine.
Machine on incline symbol
Machine on level surface symbol
: Low range operation for inclines.
: High range operation for
maximum drive speed.
or
The operating envelope indicator lights will come on to notify the
operator that a function has been interrupted and/or an action is
required by the operator.
Lower Primary Boom light flashing
the indicator light is off.
: Lower the primary boom until
or
Platform Not Level light flashing
: The tilt alarm will be sounding
when this light is flashing. The Platform Level toggle switch will only
the indicator light is off.
or
achine Not Level Light Flashing
M
: If the tilt alarm sounds when the
platform is raised, the Not Level indicator light will come on and the
drive function in one or both directions will not operate.
or
Follow the correct boom lowering sequence below based on the
platform position. Do not rotate the boom while lowering.
Uphill Position Downhill Position
Z-80/60
Loading...