Page 1
MODEL: UMD300 Series
High Resolution Internal Dome Cameras
User Manual
Technical Specication
Model Number UMD300B UMD300W
Image Sensor 1/3” Colour CCD
Total Pixels PAL : 795 (H) x 596 (V)
Effective Pixels PAL : 752 (H) x 582 (V)
Scanning System 2:1 Interlaced
Scanning Frequency PAL : H:15.625 Hz / V:50 Hz
S/N Ratio More than 50dB
Horizontal Resolution 620TV Lines
Video Output Level 1.0 Vp-p (75Ω, Composite)
Minimum Illumination 0.05Lux (50IRE@F1.2)
Electronic Shutter
Speed
Auto
PAL: 1/50sec ~ 1/100,000sec
AGC Middle
White Balance ATW (Auto Tracking White Balance)
Digital Noise Reduction On
Day & Night Colour Only
Supplied Voltage DC12V ±10%
Power Consumption Max. 1.0W [80mA]
Weight 93g
GENIE CCTV LTD.
CCTV House, City Park, Watchmead, Welwyn Garden City, Hertfordshire, AL7 ILT
Tel: +44 (0) 1707 330541 Fax: +44 (0) 1707 330543
www.geniecctv.com
Edition: GN-JUNE 2013
Page 2
Please read these instructions carefully before operating this unit,
and retain this manual for future reference
Precautions
• Do not install the camera in extreme temperature conditions. Only use
the camera under conditions where temperatures are within -10℃ ~
+50℃. Be especially careful about ventilation in high temperatures.
• Do not drop the camera or subject it to physical shocks. This can cause
malfunctions to occur.
• Do not install the camera under unstable lighting conditions. Severe
lighting change or icker can cause the camera to work improperly.
• Do not disassemble the camera. There are no user serviceable parts
inside it.
• Do not expose the camera to rain or moisture. If it gets wet, wipe it dry
immediately. Liquids can contain minerals that corrode electrical parts.
Features
• 1/3” Colour CCD
• Internal Micro Dome Camera
• Ø57mm Dome Cover
• 620TVL - High Resolution
• Min Illumination 0.03Lux
• Digital Noise Reduction (DNR)
• DC12V Only
• Black or White Housing Options
Power and Video Connection
Troubleshooting
Dimensions
Camera
Manual
Installation
Screws
Gift Box
Problem What To Do?
No video on the monitor
screen
• Check camera and monitor power.
• Check the power polarity.
• Check the video cable connection.
Colour rolling • This can occur if the camera is exposed to a
strong light source
• If there is a strong light present, change the
position of the camera.
The On-Screen image
is dim
• Check if the lens/bubble is dirty. If it is, clean with
a soft line free cloth.
• Check the monitor contrast and brightness.
Black bars roll up or down
the screen, or there is
video noise
• Make sure the power adapter is at least 500mA
• Make sure there are no ground loops
• Noise could be caused by a poor connection
PIN PITCH:1.25㎜
HOUSING:51021-03
MOLEX
12VDC : RED
BNC : YELLOW
650mm
CABLE DIAMETER : ¢4.5
PIN PITCH:1.25㎜
HOUSING:51021-03
MOLEX
35mm
Loading...