Genie UMD300 Series, UMD300B, UMD300W User Manual

MODEL: UMD300 Series

High Resolution Internal Dome Cameras

User Manual

Technical Specication

Model Number UMD300B UMD300W

Image Sensor 1/3” Colour CCD

Total Pixels PAL : 795 (H) x 596 (V)

Effective Pixels PAL : 752 (H) x 582 (V)

Scanning System 2:1 Interlaced

Scanning Frequency PAL : H:15.625 Hz / V:50 Hz

S/N Ratio More than 50dB

Horizontal Resolution 620TV Lines

Video Output Level 1.0 Vp-p (75Ω, Composite)

Minimum Illumination 0.05Lux (50IRE@F1.2)

Electronic Shutter
Speed

Auto

PAL: 1/50sec ~ 1/100,000sec

AGC Middle

White Balance ATW (Auto Tracking White Balance)

Digital Noise Reduction On

Day & Night Colour Only

Supplied Voltage DC12V ±10%

Power Consumption Max. 1.0W [80mA]

Weight 93g

GENIE CCTV LTD.

CCTV House, City Park, Watchmead, Welwyn Garden City, Hertfordshire, AL7 ILT

Tel: [phone] Fax: [phone]

www.geniecctv.com

Edition: GN-JUNE 2013

Please read these instructions carefully before operating this unit,

and retain this manual for future reference

Precautions

• Do not install the camera in extreme temperature conditions. Only use

the camera under conditions where temperatures are within -10℃ ~
+50℃. Be especially careful about ventilation in high temperatures.

• Do not drop the camera or subject it to physical shocks. This can cause

malfunctions to occur.

• Do not install the camera under unstable lighting conditions. Severe

lighting change or icker can cause the camera to work improperly.

• Do not disassemble the camera. There are no user serviceable parts

inside it.

• Do not expose the camera to rain or moisture. If it gets wet, wipe it dry

immediately. Liquids can contain minerals that corrode electrical parts.

Features

• 1/3” Colour CCD

• Internal Micro Dome Camera

• Ø57mm Dome Cover

• 620TVL - High Resolution

• Min Illumination 0.03Lux

• Digital Noise Reduction (DNR)

• DC12V Only

• Black or White Housing Options

Power and Video Connection

Troubleshooting

Dimensions

Camera

Manual

Installation
Screws

Gift Box

Problem What To Do?

No video on the monitor
screen

• Check camera and monitor power.

• Check the power polarity.

• Check the video cable connection.

Colour rolling • This can occur if the camera is exposed to a

strong light source

• If there is a strong light present, change the

position of the camera.

The On-Screen image
is dim

• Check if the lens/bubble is dirty. If it is, clean with

a soft line free cloth.

• Check the monitor contrast and brightness.

Black bars roll up or down

the screen, or there is

video noise

• Make sure the power adapter is at least 500mA

• Make sure there are no ground loops

• Noise could be caused by a poor connection

PIN PITCH:1.25㎜

HOUSING:51021-03

MOLEX

12VDC : RED

BNC : YELLOW

650mm

CABLE DIAMETER : ¢4.5

PIN PITCH:1.25㎜

HOUSING:51021-03

MOLEX

35mm