Genie Aladdin Connect Installation Manual

Installation Manual
Download the app here
www.GenieCompany.com
Table of Contents
Important Safety Information ........................................................................ 1-3
Included Parts ..........................................................................................................4
Downloading the App ..........................................................................................5
Initial Programming ..........................................................................................6-7
Installation Variables ...................................................................................... 8-11
Installation & Wiring ..................................................................................... 12-13
Final Programming and Testing ..................................................................... 14
Adding Additional Doors .................................................................................. 15
Terms of Use ....................................................................................................16-19
Troubleshooting .................................................................................................. 20
Warranty ................................................................................................................. 21
1
1-866-599-4995
TO REDUCE THE RISK OF SEVERE INJURY OR DEATH, READ AND FOLLOW ALL INSTRUCTIONS.
1. NEVER let children operate or play with the door controls.
2. Keep remote away from children.
3. Locate the wall control button: A) Within sight of door. B) At a minimum height of 5 feet, so small children cannot reach it.
4. Install the entrapment WARNING label next to the wall button or console, in a prominent location.
5. NO ONE SHOULD CROSS THE PATH OF THE MOVING DOOR.
6. NEVER GO UNDER A STOPPED, PARTIALLY OPEN DOOR.
7. The Aladdin Connect™ operating system is designed for unattended operation. The door could move unexpectedly.
8. DO NOT install Aladdin Connect™ on garage door openers manufactured prior to 1993 without photocell non-contact safety sensors.
9. DO NOT install on one-piece doors.
SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
TO REDUCE THE RISK OF SEVERE INJURY OR DEATH, READ AND FOLLOW ALL INSTRUCTIONS.
1. NEVER let children operate or play with the door controls.
2. Keep remote away from children.
3. Locate the wall control button: A) Within sight of door. B) At a minimum height of 5 feet, so small children cannot reach it.
4. Install the entrapment WARNING label next to the wall button or console, in a prominent location.
5. NO ONE SHOULD CROSS THE PATH OF THE MOVING DOOR.
6. NEVER GO UNDER A STOPPED, PARTIALLY OPEN DOOR.
7. The Aladdin Connect™ operating system is designed for unattended operation. The door could move unexpectedly.
8. DO NOT install Aladdin Connect™ on garage door openers manufactured prior to 1993 without photocell non-contact safety sensors.
9. DO NOT install on one-piece doors.
SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
translate to French
2
www.GenieCompany.com
DCM
(Door Control Module)
DPS
(Door Position Sensor)
Hardware Bag PowerPack
Wire Spool
Insulated Staple x30
Included Parts.
DPS Mounting Bracket
DPS Mounting Adheasive Strip
DPS Mounting Screws
DCM Mounting Screws
DCM Mounting Screw Anchors
3
1-866-599-4995
www.GenieCompany/Aladdin.com Visit your app store to download QR code readers.
Getting Started.
This should be some text to introduce the homeowner to this product. Something from marketing perhaps?
FCC/IC Statement: This device complies with FCC Part 15 rules and with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of this device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de license. L’exploitation est autorisée aux deux conditions suivantes: (1) I’appareil no doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit acceptor tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
4
www.GenieCompany.com
In the Home close to WiFi Router:
Prepare Aladdin Connect™ by rst scanning the QR code™ on this instruction or on the back of the DCM (Door Control Module) or visit www.GenieCompany.com to start the setup of the Aladdin Connect™ device.
1. Remove Mounting Bracket from back of DCM. (a)
2. Plug Aladdin Connect™ DCM into outlet with Power Pack. (b)
3. Download the app.
4. Create an account.
5. Begin programming.
Plug Aladdin Connect™ into wall outlet with power-pack.(c) Follow the on-screen menus to set and program system prior to wiring in the garage.
1. Pair Wi-Fi router with Aladdin Connect™ (DCM)
2. Pair Door Position Sensor (DPS) with Aladdin Connect™
Once setup is complete, move system to the garage.
WI-FI Signal Indicator
GOOD -- WEAK -- POOR
DPS Signal Blue LEDs
Power Indicator
a b
c
5
1-866-599-4995
In the Garage:
Plug powerpack into wall outlet and DCM. The RED power indicator LED should illuminate. The WI-FI signal indicator LED should illuminate signaling that the WI-FI signal is still in tact.
• A GREEN LED indicates a good WI-FI signal.
• A YELLOW LED, indicates a weak signal. Move Aladdin
Connect™ to a position that better suits the Wi-Fi signal from the router.
• A RED LED, indicates a poor Wi-Fi signal. Move Aladdin Connect™ to a position that better suits the Wi-Fi signal from the router or call 1-800-599-4995.
The DPS door sensor BLUE LED(s) on the DCM will also illuminate. (One for each door programmed).
These factors must be determined prior to mounting Aladdin Connect™ (DCM) to the wall or ceiling.
1. Optimal Wi-Fi signal strength.
2. Desired and/or garage door opener(s) wall control location.
3. Access to 110VAC outlet within 5 feet.
Once an optimal signal and location is obtained, wire the DCM to the garage door opener(s).
WI-FI Signal Indicator
GOOD -- WEAK -- POOR
DPS Signal Blue LEDs
Power Indicator
6
www.GenieCompany.com
Typical Installation
WiFi
Installed directly to the garage door opener next to wall control.
Determine Location for Wiring
Loading...
+ 16 hidden pages