TGL41-6.8 THRU TGL41-200A
SURFACE MOUNT TRANSZORB™ TRANSIENT VOLTAGE SUPPRESSOR
Breakdown Voltage - 6.8 to 200 Volts Peak Pulse Power - 400 Watts
FEATURES
♦ Plastic package has Underwriters Laboratory
Flammability Classification 94V-0
♦ For surface mounted applications
♦ Glass passivated junction
♦ Excellent clamping capability
♦ Low incremental surge resistance
♦ Fast response time typically less than 1.0ps from
0 Volts to V
(BR)
♦ 400W peak pulse capability with a 10/1000µs waveform,
repetition rate (duty cycle): 0.01%
♦ For devices with V
(BR)
≥10V, IDare typically less
than 1.0µA
♦ High temperature soldering guaranteed:
250°C/10 seconds at terminals
MECHANICAL DATA
Case: JEDEC DO-213AB molded plastic body over
passivated junction
Terminals: Solder plated, solderable per MIL-STD-750,
Method 2026
Polarity: Blue bands denotes the cathode which is positive
with respect to the anode under normal TVS operation
Mounting Position: Any
Weight: 0.116 gram, 0.0046 ounce
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Ratings at 25°C ambient temperature unless otherwise specified.
RATINGS SYMBOL VALUE UNITS
Peak pulse power dissipation with a
10/1000µs waveform
(NOTE 1, FIG. 1)
P
PPM
Minimum 400 Watts
Steady state power dissipation at T
L
=75°C
(NOTE 2)
P
M(AV)
1.0 Watt
Peak pulse current with a 10/1000µs waveform
(NOTE 1, FIG. 3)
I
PPM SEE TABLE 1
Amps
Peak forward surge current, 8.3ms single half
sine-wave superimposed on rated load for unidirectional only I
FSM
40.0 Amps
(JEDEC Method)
(NOTE 3)
Maximum instantaneous forward voltage at 25A
for unidirectional only
V
F
3.5 Volts
Operating junction and storage temperature range T
J
, T
STG
-55 to +150 °C
NOTES:
(1) Non-repetitive current pulse, per Fig. 3 and derated above TA=25°C per Fig. 2
(2) Mounted on copper pads to each terminal of 0.31 in
2
(8.0 mm2) per Fig. 5
(3) Measured at 8.3ms single half sine-wave or equivalent square wave duty cycle=4 pulses per minute maximum
1/20/99