General Pump 66 User Manual

GENERAL PUMPA member of the Interpump Group

8

CRANKSHAFT “FLIP” INSTRUCTIONS

CRANKSHAFT FLIP PROCEDURES

1) Drain crankcase oil.

HTF, TSF & TSP Series 66

Triplex Plunger Pump

TRIPLEX TRIPLEX

Fig. 1

Fig. 2

Fig. 3

Fig. 4

2) Remove qty. 4 rear cover screws with 5 mm hex wrench.
Fig. 1

3) Remove connecting rod cap bolts with 6 mm hex wrench,
respecting position and orientation of each cap. Position
connecting rod/plunger guides fully into crankcase to
allow clearance of crankshaft removal. Fig. 2 and 3.

4) Remove qty. 4 each bolts retaining side covers with
6 mm hex wrench. Fig. 4 and 5.

Ref 300887 Rev. A

General Pump
is a member of
the Interpump Group

05-12

HTF, TSF, TSP Series 66
Crankshaft Flip Instructions

5) Carefully remove side covers respecting
crankshaft oil seal. Fig. 6 and 7.

Fig. 5

6) Remove crankshaft out crankcase side cover hole
and reassemble shaft position to opposite side.
Fig. 8.

Fig. 6

GENERAL PUMPA member of the Interpump Group

Fig. 7

Fig. 8

Fig. 9

7) Reassemble side cover into crankcase starting
with closed cover respecting O-ring seals and
crankshaft seal. Fig. 9 and 10.

Torque bolts to specifications. Fig. 11.

Ref 300887 Rev. A

05-12