General Pump 2100306 Operator's Manual

e

h

T

in

a

l

Orig

• Recommended for units with
pressures of 2500 to 4500 PSI

• Quick connect to pressure washer
wand

• 3 quick-connect, quick-change
nozzles

• Easy nozzle storage for quick
adjustments

®

PATENTED

Patent No. 7,896,266

• Upright operation saves back
strain and fatigue

• Consistent and even cleaning
path

• Cleaned area is easy to see and
review

• Disconnects in a snap for easy
storage

• 5 to 6 times faster saving energy
and water

• COMMERCIAL GRADE - FIELD
TESTED FOR 3 YEARS

Revision F

052016

OPERATOR’S

MANUAL

WARNING: Using a pressure

washer involves water under

intense pressure. Never point

the water stream towards

anyone and do not get any

body parts near stream as it

could cause serious

injury

IMPORTANT NOTICE - PRIOR TO INITIAL USE:

Due to the possibility of small amounts of residue remaining after the manufacturing process, it is
important to follow these instructions:

Before Inserting Nozzles:

Flush nozzles thoroughly with water.
Attach the TRIKLEENER® to the pressure washer wand by engaging the “quick connect” fitting and run
washer at medium pressure for approx. 10-15 seconds to “Flush” the manifold.

Warning: Once unit is engaged, NEVER put any body part near water stream under any circumstances!

1. CONNECTING THE SPRAY NOZZLES
TO THE MANIFOLD

Before installing the nozzles, it is
very important to flush the Trikleener
with clean water.

Slide the outer portion of the quick
connect fitting (collar) up, insert male
portion of spray nozzle and release to
“lock in” the nozzle. Make certain that the
nozzles are aligned to ensure correct
spraying patterns.

2. CONNECTING TO PRESSURE
WASHER WAND

Utilizing the quick connect fitting on the
hand wand of the unit, connect directly
onto the top of the TRIKLEENER male
fitting.

3. SETTING THE HEIGHT ADJUSTERS

Pushing the metal tab, release the bar
so that settings are possible. The
lower the setting, the closer the unit will
be to the ground, increasing the velocity
of water and increasing the cleaning
power. By raising, it decreases the
velocity thereby creating a “gentler”
stream for painted surfaces.

4. UTILIZING THE TRIKLEENER TO ITS
MAXIMUM CLEANING POWER

The unit is designed to be best used at
approximately a 45 degree angle to
push the dirt and grime away from the
user. There are two methods found
effective. The first is using the unit in a
“vacuum cleaning” motion, and the other
is to roll the unit in a straight line in a
slow and deliberate manner. Each
method has been found to be effective.