General Pipe Cleaners Uni-Stand Operating Instructions

Uni-Stand ™

Operating Instructions

General’s Uni-Stand supports your hand-held drain cleaner while you’re working in tight spaces under kitchen and bathroom sink cabinets. It fits the Super-Vee®, Power-Vee®, Handylectric® and BD Drain Gun. It fits many competitive hand-held drain cleaners as well.

FEATURES:

Read, understand and follow all safety warnings and instructions provided with your drain cleaning machine. Failure to follow the warnings and instructions may result in electric shock and/or serious injury. Save all warnings and instructions for future reference.

Locking Buckle

Height Adjustment Knob

Receptor

Strap

Leg

ASSEMBLY:

1. Open the clamp by lifting the locking buckle.

2. Push and hold receptor where indicated to open

and fully release the strap.

3. Close the locking buckle.

4. Lay the drain cleaning machine on its side on a flat surface. Place the Uni-Stand onto the drill housing.

Note: You may prefer to mount the Uni-Stand on top of the motor housing (as shown here) so that your machine operates upside down. This offers easier access to the trigger switch during operation.

5. Wrap the strap around the drill and slide it into the

receptor until snug.

6. Release the locking buckle and push the strap into the receptor an additional 2-3 clicks, then close the locking buckle firmly to clamp the Uni-Stand securely into place.

Uni-Stand™

7. Turn the knob counter-clockwise to release the

leg. Push/pull the leg to adjust it to the height you need to work comfortably. Then, turning the knob clockwise to secure the leg in position.

OPERATION:

1. Place your machine within one foot of the drain

opening.

4. Squeeze the trigger and rock the machine forward

as the cable spins into the line.

5. Slide the Grip Shield forward to release the Snake

Grippers (or rotate the chuck to release the cable) and rock the machine back.

2. Slide the cable into the drain as far as it will go.

3. If you are using the Super-Vee, pull back on the

Grip Shield to engage the Snake Grippers. If you are using the Handylectric or BD Drain Gun, turn the chuck to lock or release the cable.

General Wire Spring Co,

1101 Thompson Avenue McKees Rocks, PA 15136

412-771-6300 www.drainbrain.com

6. Repeat rocking the machine forward and back as you feed the cable into the line.

Note: If you are using the Power-Vee, position the machine within 6 inches of the drain opening. Pull the trigger, then squeeze the feed lever to feed the cable into the line. When you meet an obstruction, rock your machine forward and back as you work though the stoppage.