General Lock WP-380 User Manual

WP-380 Users Manual and Installation Instructions

WP-380 Camera Users Manual and

Installation Instructions

I. General

The WP-380 series of cameras contain a CCD camera in a stylish and attractive
waterproof housing. WP-380 series uses a high sensitive 1/3” color interline transfer
CCD sensor with low lux performance.

II. Precautions

• Do not expose the camera to humidity and dust. If the camera is mounted outdoor,
a camera housing is required.

• Handle with care. This camera consists of high sensitive parts. Do not disassemble
it or place it on an unstable base.

• Do not touch the surface of CCD sensor by hand directly. When the camera is not
in use, put the cover cap on the lens.

• Never face the camera toward the sun.

• Use N.D. filter or set large F number of manual lens when the light intensity is very
high, in order to protect the sensitive CCD sensor.

• Use proper power source otherwise the camera will not function correctly. Operate
on DC +12V (Use a regulated power source only).

III. Part Names

IV. Installation Instructions

1. Connect the camera with the mounting bracket (supplied).

2. Remove the bracket base from the mounting bracket.

3. Using the supplied screws, mount the bracket base in the desired location.

4. Reassemble the bracket with the camera onto the mounting

5. Loosen the swivel screw and then point the camera in the desired direction.

6. Tighten the swivel screw.

7. Connect the BNC connector of the camera to a monitor or other video device
through a 75 ohm type coaxial cable with BNC female connector at cable extension.

8. Connect the DC+12V regulated power source of the camera (DC Jack) to the
DC12V power-in jack with 2mm, center+ outer- plug.

WP-380 Users Manual and Installation Instructions

9. Our factory settings is for you to get the best image within 3~5 Meters. If it is out
of focus, you can also adjust the focus according the following procedures.

a. Remove the three fixing screws, which hold the housing cover.
b. Carefully pull the housing cover from the back plate.
(Please pay attention to prevent damage to the “O”-Ring seal.)
c. Loosen the lens mount fixing screw located at side of the lens by using the
L Wrench (supplied).
d. Adjust the lens to bring the subject into focus.
e. Secure the lens mount fixing screw firmly again.
f. Overlaying the cover gently in order to prevent damage to the “O”-Ring and
camera components.

Notes:

(A)Make wiring connections only after it has been determined that power has
been disconnected. Use only a 12VDC power supply for the WP-380 series
(300 mA minimum recommended).

(B)There is a desiccant pack attached to the housing base under the camera,
which is designed to absorb any moisture trapped inside the housing during
adjustment. To avoid excessive moisture build up, it is recommended that the
camera not be installed in rainy or excessively damp conditions. It is also
advisable to limit the number of times the housing cover is removed. The
desiccant pack can be replaced if condensation develops inside the housing.