WATERFARM PARTS
1 2 3 4 5
96 107 118
WATERFARM PARTS:
1) Clay Pebbles (not included with WaterFarm Controller 8-Pack
or Modular units)
2) Flora Series Nutrients (8oz bottles)
3) 4 Gal Reservoir (deep chamber for water)
4) 2 Gal Growing Chamber (shallow pot with perforated bottom)
5) Elite 800 Air Pump
6) Drip Ring Assembly (circular plastic ring attached to tee)
7) DLT Clip
8) Air Line (clear tubing)
9) Pumping Column (2-piece white tube with air inlet at bottom)
10) Pumping Column Support Tube (tube with bevel facing down)
11) Drain Level Tube (translucent blue tube fitted to barbed elbow)
STEP 1
Insert black DLT Clip into
Reservoir as shown.
STEP 2
Install the blue Drain Level Tube by
inserting the elbow through the rubber
grommet from the outside while
supporting the grommet from the inside.
The Drain Level Tube is supported by the
DLT Clip for normal operation and rotate
the Drain Level Tube level with the bottom
of the Reservoir to drain the system.
ASSEMBLY
STEP 3
Place the Growing Chamber
on the Reservoir.