General Hydroponics PowerGrower 8-Pack User Manual

PowerGrower
8-Pack
Assembly Guide
®
POWERGROWER 8-PACK PARTS ASSEMBLY
181
2
3
4 6 75 9 10 11 12 13 14
8
17 16
POWERGROWER 8-PACK PARTS:
15
STEP 1
end with the washer on the inside of the Controller (part 1), through the predrilled hole in the Controller and secure from the outside with the nut. Coat the remaining threads with the Pipe Thread Compound and screw on the brass 1/2” barbed hose fitting.
Pipe Thread Compound
1: Reservoir & Controller (2) 2: Reservoir & Controller Lid (2) 3: Hatch Cover (2) 4: Reservoir & Controller Connecting Hose 5: Float Valve with pipe thread compound 6: Controller Drain Level Tube 7: Circulating Pump Column with Collar 8: Circulating Pump Connector with Split Tee 9: Drip Rings (8) 10: Clear Airline (8) 11: Pumping Columns with Support Tubes (8) 12: Individual Drain Level Tube with 1” grommet reducer 13: Blue Tubing (20 ft.) 14: Split Tees (8) 15: Single Output Air Pump 16: Individual Reservoir (8) 17: Growing Chamber (8) 18: Dual Diaphragm Air Pump
ASSEMBLY ASSEMBLY
STEP 2
Insert the Drain Level Tube (part 6) into the 1/2” grommet on the side with the support tab. Insert Circulating Pump Connector with Split Tee (part 8) into the 1” grommet opposite the Drain Level Tube and support the grommet from the backside while securing the Split Tee into the grommet.
STEP 3
Insert the Circulating Pump Column (part 7) into the tabs on the bottom of the Controller (part 1) and push the collar down over the tabs. Insert the Y-fitting from the Circulating Pump Column into the elbow from the Circulating Pump Connector (part 8)
STEP 4
Make sure the black airline is securely inserted into the Y-fitting and thread the other end thru the cap in the Controller Lid (part 2). Place one of the Hatch Covers (part 3) over the access hole in the Controller Lid
STEP 5
Place the Reservoir (part 1) on top of the assembled Controller. Connect the Reservoir to the Controller by inserting the 1/2” straight barbed fitting of the Connecting Hose (part 4) into the 1/2” grommet on the Reservoir and connect the other end of the blue tubing to the brass barbed fitting of the float valve. Place the Reservoir Lid (part 2) with
the Hatch Cover (part 3) on the Reservoir.
Loading...
+ 4 hidden pages