General Electric PTWN6250MWT User Manual

PTWN6250M

25-1/2

GE Profile™ 4.3 IEC cu. ft. stainless steel capacity washer

Dimensions and Installation Information (in inches)

Circuit Requirements: An individual, properly-grounded branch

circuit, with a three-prong grounding-type receptacle, protected by a 15 or 20 amp circuit breaker or a time-delay fuse, is required.

Electrical Rating: 120V, 60Hz, 10A

Note: Washer wall outlet must be located within 36" of service

code entry. Wall outlet must not be located behind dryer.

Installation Information: Before installing, consult installation instructions packed with product for current dimensional data.

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service,

800.626.2000.

Side View

Rear View

Specification Revised 1/11

Listed by Underwriters Laboratories

260192

PTWN6250M GE Profile™ 4.3 IEC cu. ft. stainless steel capacity washer

Features and Benefits

• ENERGY STAR® qualified and CEE Tier II rated - Meets or exceeds federal

guidelines for energy efficiency for year-round energy and money savings

• HydroWave wash system with HE LoWater wash and Infusor™ - Utilizes the

concentrated power of HE detergent, requiring less water than a traditional topload washer to get clothes clean

• PreciseFill - Washer will automatically measure the load size and add just the

right amount of water

• 700 RPM spin speed - Fast speeds remove more water during the spin cycle to minimize drying time

• GE Profile warranty - Offers a lifetime warranty on the stainless tub and a

limited ten-year parts warranty, providing peace of mind and dependability

See written warranty for details

• Speed Wash - Provides a quick wash for lightly soiled items that are needed

in a hurry

• Specialty cycles - Pre-set cycles are designed to provide superior care for

specific items

• Quiet-By-Design

™

- Special insulating materials help muffle operating noise

• Model PTWN6250MWT – White

Modified Energy Factor (MEF)

Water Factor (WF)

Specification Revised 1/11

2.20

4.50

260192