General Electric JX36CSS, JX36BSS Installation

Installation Filler Panel Kit Instructions
JX36
FOR 36” INSTALLATIONS
Kit Model
JX36B CVM1750/CVM1790/PVM9179/
CSA1201/PSA9120/PSA9240
JX36C JVM6170/JNM6171/JVM6172/
JVM6175/JVM6177
JX36D JVM7195/DVM7195/JNM7196/
PVM9195/PNM9196/PVM9215
TOOLS YOU WILL NEED
Phillips screwdriver
PARTS INCLUDED
Connecting Bar (1)
Installation screws (2)
49-40720-1 10-14 GE
Installation Instructions
Install the OTR bracket according to OTR Installation Instructions.
NOTE: This kit is best installed with 12” base cabinets. Cabinets with greater than a 12” base may have a larger gap between back wall and kit.
NOTE: Ensure the OTR and the Cooking Product installation manuals are followed.
OTR Bracket
KIT INSTALLATION
1. Place the microwave on a flat surface where you can work on the bottom of both sides.
2. Remove all 3 pieces from the package (right panel, left panel, top brace.
3. Remove the screws from the lower back of the microwave.
4. With the short edge of the side trim to the back of the left side of the microwave, and using the screw you just removed, attach the side trim to the back of the microwave.
Screw Holes
5. Your microwave will have one or two screws on the bottom left side. Remove these screws to create a gap between the bottom plate and the case of the microwave.
6. Slide the lower lip of the side panel inside the gap between the bottom plate and the case. Attach using the screws you removed in step 5.
Printed in USA
7. Make adjustments so the side panel is in line with the front of the microwave case.
Flush with front of microwave case.
8. Repeat the same procedure for the other side.
9. Using the 2 flat head screws provided, attach the top brace to the 2 side panels to pull both panels together.
10. Install the over-the-range microwave with side
panels into the 36” opening.
NOTE: Make sure you have installed the mounting wall bracket in the center of the 36” opening per the installation instructions provided with your microwave.
2
Loading...