General Electric JX15BUMPBB Installation
Installation Bump-Out Kit
Instructions
For 15” Deep Cabinets
JX15BUMP
49-40719 07-14 GE
Installation Instructions
TOOLS YOU WILL NEED
#1 and #2 Phillips screwdriver
Tin snips (for cutting
damper, if required)
Gloves
Scissors
(to cut template, if necessary)
Pencil
Ruler or tape
measure and
straight edge
Electric drill with
1
⁄2” and 5⁄8” drill bits
3
⁄16” , 7⁄16”, 3⁄8”,
Carpenter square
(optional)
Filler blocks or scrap
wood pieces, if needed
for top cabinet spacing
(used on recessed
bottom cabinet
installations only)
Saw (saber, hole or keyhole)
Safety goggles
MOUNTING SPACE
NOTE: Maximum cabinet depth is 15”.
1
16-
⁄4”
30
”
2”
66” or more
from the
floor to the
top of the
oven
30”
min.
Backsplash
Stud finder or
Bottom edge
of cabinet
needs to
be 30” or
more from
the cooking
surface
Hammer (optional)
Level
Duct and masking tape
NOTES:
• The space between the cabinets must be 30” wide
and free of obstructions.
• If the space between the cabinets is greater
than 30”, a Filler Panel Kit may be used to fill
in the gap between the oven and the cabinets.
Your Owner’s Manual contains the kit number for
your model.
• This oven is for installation over ranges up to
36” wide.
• If you are going to vent your oven to the outside,
see Hood Exhaust Section for exhaust duct
preparation.
• When installing the oven beneath smooth, flat
cabinets, be careful to follow the instructions
on the top cabinet template for power cord
clearance.
2
Loading...